User manual SAECO HD8745/01 XSMALL CLASS

[. . . ] A Via Torretta, 240 - 40041 Gaggio Montano (Bo) - Italy declare under our responsibility that the product : AUTOMATIC COFFEE MAKER SUP 033R to which this declaration relates is in conformity with the following standards or other normative documents : • Safety of household and electrical appliances - General requirements EN 60335-1(2002) + A1(2004) + A2(2006) + A11(2004) + A12(2006)+ A13(2008) • Safety of household and electrical appliances - Part 2-15 Particular requirements for appliances for heating liquids EN 60335-2-15(2002) + A1(2005) + A2 (2008). • Household and similar electrical appliances - Electromagnetic fields - methods for evaluation and measurement - EN 62233 (2008). €¢ Household and similar electrical appliances - safety - Part 2-14 Particular requirements for kitchen machines EN 60335-2-14 (2006) + A1 (2008). 3^ Limits - Section 2 : Limits for harmonic current emissions (equipment input current ≤ 16A for phase) EN 61000-3-2 (2006) • Electromagnetic compatibility (EMC) - Part 3^ : Limits - Section 3 : Limitation of voltage changes , voltage fluctuations and flicker in public low - voltage supply systems , for equipment with rated current ≤ 16 A for phase and not subject to conditional connection EN 61000-3-3 (1995)+ corr. [. . . ] Note: During the turning off phase, the machine performs a rinse cycle, if a coffee product has been brewed. To turn the machine on again, simply press the ON/OFF button; in this case the machine will go through the rinse cycle only if the boiler is cold. 1 2 • 11 • COFFEE BREWING Before brewing coffee, make sure that the green temperature light “ “ is steady on and that the water tank and the coffee hopper are full. Leave the control dial on the coffee position “ ” during the dispensing phase. • Place 1 or 2 cups under the dispensing spout. €¢ To brew coffee, press and release: the “ “ button for an espresso coffee; the “ “ button for a long coffee. €¢ To dispense 1 cup of coffee, press the button once. To dispense 2 cups of coffee, press the button twice. In this operating mode, the machine automatically grinds and doses the correct amount of coffee. Brewing two coffees requires two grinding cycles and two brewing cycles, automatically carried out by the machine; this option is indicated by the “ “ light being constantly on. €¢ After the prebrewing cycle, coffee begins to dispense out of the dispensing spout. €¢ Coffee brewing stops automatically when the pre-programmed level is reached; however, it is possible to interrupt coffee brewing by pressing the button initially pressed. The machine is adjusted to brew a true Italian espresso coffee. This feature may slightly lengthen the brewing time, allowing the intense flavor of the coffee to develop fully. Steady on Steady on Warning: Dispensing may be preceded by short sprays of hot water, and scalding is possible. The hot water/steam wand may reach high temperatures. Do not touch it with bare hands; use the appropriate handle only. €¢ Before dispensing hot water, check that the green temperature “ “ light is steady on. When the machine is ready, proceed as follows: • Place a container under the hot water / steam wand (Pannarello, if supplied); • Turn the control dial clockwise to set it to the “ ” position. €¢ Fill the cup with hot water to the desired level; to stop hot water dispensing, turn control dial counter-clockwise back to the “ ” position. The machine returns to the normal operating mode. Occasionally, after turning the control dial, hot water may not be dispensed and the “ “ light may blink slowly. [. . . ] The hole of the hot water / steam wand is clogged. Solutions Connect the machine to the power source. Clean the hole of the hot water / steam wand using a pin. Make sure that the machine is turned off and has cooled before performing this operation. [. . . ]