User manual SAECO PRIMEA RING

[. . . ] Operation and maintenance manual Before using the machine, please read the attached operating instructions. Carefully read the safety rules FOR HOUSEHOLD USE ONLY IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. To protect against fire, electric shock and injury to persons do not immerse cord, plugs, or appliance in water or other liquid. Close supervision is necessary when the appliance is used by or near children. [. . . ] a large enough container is positioned under the spout; 2. the milk container has been correctly inserted in the machine; 3. the water tank contains a sufficient quantity of water. 1 machine settings maintenance 2 maintenance milk circ. rinse cycle 5 AFTER USE, ALWAYS REMOVE THE MILK CONTAINER AND PUT IT IN THE REFRIGERATOR. The container may be left in the machine only if it has been washed with drinking water and it does not contain milk; see page 38. Wait for the cycle to complete. Remove the container, rinse and dry. 24 PROGRAMMING THE MACHINE > machine settings > maintenance > coffee cleaning cycle Coffee wash cycle To clean the machine's internal circuit used for brewing coffee. To wash the Brew Group, simply clean with water as shown on page 40. This wash completes maintenance of the Brew Group. Packages of Saeco detergent tablets may be purchased at your local dealer or by Authorized Service Centres. It is advisable to perform this wash cycle after 500 coffee brewing cycles, or monthly. Note: before performing this function make sure that: 1. a large enough container is positioned under the spout; 2. the appropriate tablet for cleaning the brew group has been inserted into the compartment for pre-ground coffee; 3. the water tank contains a sufficient quantity of water THE WASH CYCLE CANNOT BE INTERRUPTED. A PERSON MUST BE PRESENT DURING THE OPERATION. 1 machine settings maintenance 2 maintenance coffee cleaning cycle 3 yes coffee cleaning cycle 1. 2. 4 insert cleaning tablet coffee cleaning cycle 5 in progress coffee cleaning cycle 6 done coffee cleaning cycle Insert the tablet as shown above. Press to start. Wait for the cycle to complete. When the cleaning cycle has finished, press to confirm. 7 THE MAINTENANCE AND CLEANING OF THE BREW GROUP IS DESCRIBED ON PAGE 40. (see page 18) 25 Milk wash cycle > machine settings > maintenance > milk cleaning cycle To clean the machine's internal circuits used for preparing milk. This cycle is proposed after 14 days from the first dispensing of a milk-based beverage. After 14 days, the "milk circuit washing" message starts flashing (see page 13). Perform the washing cycle as indicated in this section. If the milk circuit washing cycle is not performed, dispensing milk-based products will be possible for only 7 more days. After 21 days (the machine warns the user 3 days before the deadline is reached with the message "milk circuit washing -3"), the "milk circuit washing" message stops flashing and appears any time the button to select a milk-based beverage is pressed. At this point, the milk circuit washing cycle must be performed, because the dispensing of milk-based beverages is disabled. [. . . ] · Before cleaning the machine, the main switch must be turned to OFF (0), unplugged from the socket and cooled down. · Keep the appliance from coming into contact with splashes of water or immersing in water. · Do not dry the machine's parts in conventional or microwave ovens. · The machine and its components must be cleaned and washed after the machine has not been used for a certain period. REPLACEMENT PARTS For safety reasons, use only original replacement parts and original accessories. WASTE DISPOSAL - The packing materials can be recycled. [. . . ]