User manual SAECO TYPE SIN 006

[. . . ] We congratulate for having bought this top-quality espresso machine and many thanks you for your confidence in our products. Before operating the machine, we recommend to read the following instructions thouroughly which explain how to use, clean and maintain the machine. This espresso machine can brew one cup of espresso or two cups simultaneously and comes equipped with a moveable steam/hot water arm. Controls on the front of the machine are easily recognizable by their corresponding icons. [. . . ] Do not place the machine outside or near hot surfaces or open flames in or- SETTING UP THE MACHINE AND USE our from the front of the machine. The filter, without pressing it, in order to obtain 1 or 2 espresso servings. With the special "Crema" (G) filter holder supplied with the machine it is not necessary to change the filter for one or two servings. 17 Insert the filter holder into the brew head, turning from left to right until it locks into place. 18 Place the one or two cups on the drip tray (9) below the filter holder ensuring that they are correctly positioned under the coffee spouts. Make sure that the green "ready" light (2) is on then press the coffee button (5). Rinse the tank and fill it with fresh water. Make sure the water tube hangs straight into the tank. The water tank also can be filled without removing the tank. Simply pour water into the water tank funnel (12). Always fill water tank only with fresh, non-sparkling water. Never fill with hot water or other liquids that could damage the tank. Before setting up the machine, heed the following safety precautions: · place the machine in a safe place; · Keep children away from the machine; · Do not place the machine on hot surfaces or near open flames. If an extension cord is used, make sure that it has a minimum diameter of 1 mm² and that it has a three-pole outlet/ plug. the voltage of the machine has been set during production at the factory. Make sure that the voltage of the power mains corresponds to that on the rating plate underneath the machine. Make sure that the main switch (3) is in the "0" position before plugging the machine into the electrical outlet. Before turning the machine on, always make sure that the water tank is filled. Before the first use of the machine, after a prolonged period without use, whenever the water tank has run completely dry, or after drawing steam the system must be primed. Insert the filter holder (G) into the brew head (4) to pre-heat the filter holder. [. . . ] ⷠ16 Let the machine heat up and empty out the water remaining in the container by turning the steam knob counterclockwise; to cut off flow turn the knob clockwise. Should you use a descaling agent other than the one recommended you are advised in any case to follow the manufacturer's directions on the package. Use caution when dispensing hot water, as small spurts of hot water may occur. The green "ready" light (2) will turn off until the machine reaches the correct temperature. [. . . ]