User manual SAGE APPLIANCES BAMBINO

[. . . ] At Sage® we are very safety conscious. we design and manufacture appliances with your safety foremost in mind. We also ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions. Before using for the first time, please ensure that your electricity supply is the same as shown on the rating label on the underside of the appliance. [. . . ] pRE-PROGRAMED SHOT VOLUME ­ 1 CUP Press the 1 CUP button once, the button will flash indicating that it has been selected. a preset single espresso volume of approximately 30mls will be extracted. The machine will automatically stop once the pre-set volume has been extracted. Insert the RazorTM tool into the coffee basket until the shoulders of the tool rest on the rim of the basket. Rotate the RazorTM dosing tool back and forth while holding the portafilter on an angle over the knock box to trim off excess coffee grinds. Your coffee filter is now dosed with the correct amount of coffee. Press the 2 CUP button once, the button will flash indicating that is has been selected. a preset single espresso volume of approximately 60mls will be extracted. The machine will automatically stop once the pre-set volume has been extracted. Pressing the 1 CUP or 2 CUP buttons during a programmed espresso will immediately stop the extraction. MANUAL PRE-INFUSION AND SHOT VOLUME Press and hold the 1 CUP or 2 CUP button for the desired pre-infusion time. PROGRAMMING SHOT VOLUME Press and hold the 1 CUP and 2 CUP buttons for 2 seconds, the buttons will illuminate and flash. Press the 1 CUP button to start the extraction. Press the 1 CUP button again to stop the extraction. To set the 2 CUP volume, follow the above steps but select the 2 CUP button to start and stop the extraction. The machine has 3 milk temperature settings; When turning on the espresso machine, the milk The machine has 3 milk foam settings; When turning on the machine, the milk foam setting will default to the last chosen setting. Press the MILK FOAM button until the desired foam setting is illuminated. Do this press the STEAM button to start purging and press it again to stop. Fill the milk jug to between the min and Lift the steam wand and insert into the milk jug. The milk jug must rest on the milk temperature Sensor located on the drip tray and the milk should cover the steam wand tip. Press the MILK TEMP and MILK FOAM buttons to select the desired settings. Press the STEAM button, the button will flash while texturing. [. . . ] After tamping, trim the coffee dose using the RazorTM dose trimming tool. Allow time for the machine to reach operating temperature. Push water tank down completely to lock into place. No action required as this is the normal operation of the machine. [. . . ]