User manual SAGE SES875

[. . . ] At Sage® we are very safety conscious. we design and manufacture appliances with your safety foremost in mind. We also ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions. Before using for the first time, please ensure that your electricity supply is the same as shown on the rating label on the underside of the appliance. [. . . ] Then within 8 seconds, insert the steam wand tip (1­2cm) below the surface of the milk, close to the right hand side of the jug at the 3 o'clock position and quickly turn the dial back to the STEAM position. Pausing the steam avoids the milk splashing out of the jug (this pause function lasts for 8 seconds only). The indicator strip on the milk jug will change colour to highlight the exact milk temperature. We recommend milk temperature to be between 60-65°C. Once the milk is at the correct temperature (60­65°C), return the dial to the STANDBY position BEFORE removing the jug. Immediately wipe the steam wand with a damp cloth. Then, with the steam wand tip directed over the drip tray, briefly turn steam on to clear any remaining milk from inside the steam wand. Press the POWER button to switch the machine off. Press & hold the PROGRAMME button, then press the POWER button. The illuminated button will indicate the current temperature selected. To adjust the water temperature, press one of the following buttons within 5 seconds of entering Advanced Temperature Mode. The machine will beep twice to confirm the change. If no buttons are pressed within 5 seconds after entering Advanced Temperature Mode, no change will be made & the machine will return to STANDBY mode. After 5 minutes of continuous steaming, the machine will automatically disable the steam function. When this occurs return the dial to the STANDBY position. The machine automatically switches to AUTO OFF mode after 30 minutes. Set current month Soak lter for 5 min Replace lter after 90 days or after 40L The provided water filter helps prevent scale build-up in and on many of the inner functioning components. Replacing the water filter after three months or 40L will reduce the need to descale the machine. The limitation of 40L is based on water hardness level 4. If you are in level 2 area, you can increase this to 60L. The 1 CUP button should flash continuously and remain constant once the descaling process has finished. To terminate the descaling within 25 seconds, press the 1 CUP button again. [. . . ] Press the POWER button to switch the machine off and unplug from the power outlet. Allow to cool for about 30­60 minutes. Clean and clear grinder chamber and chute. Clean and clear grinder chamber and chute. [. . . ]