User manual SAGEM WP 1130

[. . . ] The telephone you have purchased complies with the DECT standard. However, if you register a Type 32 or 33 handset at the base station, the functions which do not comply with the DECT standard will not be available. Your mobile communication system has a radio module at its disposal which has a range of up to approximately 300 metres if used outdoors and up to approximately 50 metres indoors (the range can be reduced by metal objects (e. Reinforced concrete) in the immediate vicinity or by a television or other electrical appliances (with the exception of the base station). [. . . ] In order to deactivate the keyguard you must press the (links) and then *. Press the MENU key several times until Telephone is displayed. Press the MENU key several times until LCD Contrast can be seen. Press the Back key several times or wait 20 seconds until the telephone switches back into the idle condition. Selecting the priority handset for incoming calls If you have more than one handset, you can determine which of the handsets will ring first in the event of an incoming call. The other handsets will also ring, but with a slight delay. If you prefer, all handsets can be programmed to ring at the same time (Setting: Priority All). Enter the number of the priority handset (e. If you have entered the incorrect pin, Wrong Pin will appear on the display first and then the menu with the priorities you can choose from. N Rings and Delay will be alternately displayed (n is the number of rings which is to be used as the delay). Press the MENU key several times until Telephone is displayed. Press the MENU key several times until Select Base appears. Making Link will be displayed for a short period of time. Wait until this message has disappeared. If Making Link is displayed again, it means that the handset cannot find a base station or that the base station has not been plugged in. Press the MENU key several times to increase the number of rings (a maximum delay of 9 rings is possible). Press the SAVE key to save this setting. handset will then appear on the display. Press the Back key several times or wait 20 seconds until the telephone switches back into the idle condition. If you have entered the correct pin, you will hear a confirming signal. The numbers designate the handsets which are registered at the base station (between 1 and 5). You can set the telephone in such a way that particular numbers cannot be dialled (for example all international numbers or all numbers which begin with 06). [. . . ] When you are asked to enter the pin of the base station, enter the code of the other base station (you will find the pin in the manual supplied with the base station of the other manufacturer). Registering the handset of another manufacturer at the base station of the WP 1130 Follow the steps described in the manual supplied with the handset of the other manufacturer. If required, switch the base station into the registering mode as described in this manual. Enter the pin of the WP 1130 base station with the handset of the other manufacturer when you are asked to do so. [. . . ]