User manual SAITEK CYBORG 3D STICK

[. . . ] It is strongly recommended that if you have USB capability on your computer, you should use that connector to attach this device. The USB connector has many benefits over the older game port connector and is rapidly becoming the standard interface connection for quality computers. Important Notice: Connect your controller via only ONE of the above methods. Important Notice: If you connect the Cyborg 3D Stick, using the USB connector, before installing the Saitek Gaming Extensions software, the Saitek Cyborg 3D Stick will not function correctly. To solve this problem, run the NukeUSB utility (found on the Saitek Product Companion Disc CD) to remove the Cyborg 3D Stick from the Registry, restart the machine and then continue the installation as detailed above. [. . . ] Replace the screw, and tighten using the adjustment tool (4) L L L Using the Saitek Adjustment Tool push the locator pin inwards, until it has cleared the hole in the tilt adjustment plate (see figure 5). Tilt the joystick head until the locator pin isn't sitting under a hole, and remove the adjustment tool from the locator pinhole. Tilt the head until the pin locates into the next hole. The pin is sprung, so it will automatically locate into a new hole, once positioned correctly. Repeat for all positions, until you find the position, which meets your preference. Hand size adjustments L Head Roll Angle (Left/Right) Adjustment Fig. 6 Fig. 7 L L The palm rest height can be adjusted, making the stick fit your hand perfectly. Follow points 1and 2 from the previous section, refitting the palm rest to the height that best suits your hand size. Repositioning the Throttle Control The control head has three roll positions, which can be set using the roll adjustment screw at the front of the control head (see figures 6 and 7): The throttle control can also be adjusted to suit left-handed use. L L Using the adjustment tool remove the screws on either side of the throttle control. The throttle handle and the opposite cover can now be removed. Swap the throttle handle and the cover over, and replace the screws in each side. Tighten the screws using the adjustment tool. L L Using the adjustment tool unscrew the head roll adjustment screw by 3 complete turns. Once loosened off, push the head towards the back of the joystick (towards the throttle). The roll-locating pin (see figure 6) will now move out of its current position, allowing the head to be rolled either left or right. The locator pin is in the middle of the control head, above the main trigger. [. . . ] THEREFORE, IF YOU MAKE A MISTAKE, SIMPLY HIGHLIGHT THE COMMAND LINE AND TYPE IN THE CORRECT ENTRY. For a full guide to programming your Saitek Cyborg 3D Stick with SGE, see the Saitek Gaming Extensions: User Manual supplied on the Saitek Product Companion CD that came with this product. Technical Support The Saitek Website If you have access to an Internet connection, many of your technical queries may be answered with a simple visit to the Saitek Website at: http://www. saitek. com The technical support area will provide you with all the information you need to get the most out of your controller, solve any problems you might have and provide you with the latest game configurations. The site also contains regularly updated material including information about: Quick Start Guide to Programming Your Controller Creating a Profile for a Game 1 2 Open the SGE software by double-clicking on the SGE icon. [. . . ]