User manual SAITEK ECO 900

[. . . ] Using the Saitek Pro Flight Multi Panel Button Autopilot function AP Master switch to engage or disengage the autopilot HDG Plane will fly to selected compass heading NAV Plane will fly to selected NAV1 frequency or GPS IAS Plane will fly at selected indicated airspeed ALT Plane will fly to and maintain selected altitude VS Plane will climb or descend at selected vertical speed APR Plane will fly on approach to runway localizer REV Plane will fly on a back course from the localizer Adjusting autopilot settings To change the values of the autopilot settings, first turn the selector switch on the left side of the panel to the function you want to adjust. Turn the rotary control to the right of the LED display to increase or decrease the values for the function you have selected. For example, if you want to adjust the altitude setting, first turn the selector switch on the left to ALT and then increase or decrease the desired altitude setting using the rotary controls on the right. To engage any of the autopilot functions, first select the function, eg, HDG, NAV etc and then press the autopilot master switch. [. . . ] If your FS X software does not recognise the multi panel, unplug the USB cable and plug it back in. If FS X appears not to load, this is because it is waiting for a prompt. To view the prompt window, select it either by pressing Alt + tab or by clicking on the prompt on the Windows task bar. The prompt reads "Microsoft Flight Simulator security warning : will happen once after install". Click Run and when asked "would you like to designate this module? " , click yes and FS X will continue to load. The Pro Flight Multi Panel will not register automatically if you have installed the Pro Flight multi Panel before installing FS X. Technical Support Nearly all the products that are returned to us as faulty are not faulty at all - they have just not been installed properly. If you experience any difficulty with this product, please first visit our website www. The technical support area will provide you with all the information you need to get the most out of your product and should solve any problems you might have. If you do not have access to the internet, or if the website cannot answer your question, please contact your local Saitek Technical Support Team. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and; 2. This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna; - Increase the separation between the equipment and receiver; - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected; - Consult the dealer or an experienced radio/TV technician for help. , 7480 Mission Valley Rd, Suite 101, San Diego, CA 92108-4406 Canada ICES-003 Operation is subject to the following two conditions: 1. This device may not cause interference, and; 2. This device must accept any interference, including interference that may cause undesired operation of the device. [. . . ] Fate click su Esegui e quando viene chiesto "would you like to designate this module?("Do you want to run this program from Saitek? ") y "¿Siempre quiere ejecutar este programa de Saitek?" ("Do you always want to run this program from Saitek? [. . . ]