User manual SAITEK SEA BATTLE

[. . . ] After reading the Disclaimer, select the I accept the terms of the Disclaimer option and click Next to continue. At the Driver Setup screen, if you haven't already done so, plug the USB cable into one of your computer's USB ports and click on Next. When the Saitek Controller screen appears, try out all your controller's buttons and controls to determine if it is working properly. The Programming Software can be installed at a later date by following instruction (B). [. . . ] For example, you may want to move your stick in the X axis only, but find it difficult to avoid moving it in the Y axis as you do so. You can set up a deadzone in the Y axis so that these minor movements are not detected by the drivers. Each axis is represented by a white box that contains a red line displaying where the axis is currently sitting. moving the corresponding axis moves the red line. Use this line to determine exactly where your deadzone must begin and end. You can use this to help specify the size of each deadzone. For each axis (white box) there are 4 arrows that sit directly under the box on a slider (the slider controls on the top of the X, Y and Rudder axes will be explained later), 2 in the middle and 1 at each end. The 2 in the middle are for the center point of the axis and the ones at either end are for the top and bottom of the axis. Whilst left-clicking and holding the mouse button down, move the arrow along the slider; you will notice that there are 2 arrows moving along the slider; moving 2 arrows at once will help you to maintain the deadzones correctly. You can drag the arrows to any point you wish. The grey area that appears when you are moving the arrows is known as the deadzone. You can then move the sliders, which are underneath the buttons, to your desired force. You will notice that the actual forces being applied to the stick are registered above each of the sliders. At the bottom of the screen there is a Force Units icon. Clicking this will scroll through force units that are available to use. these are: Kilograms Force (Kgf) , Newtons (N) and Pounds Force (Lbs). Once the force settings are tested and set to the desired level, click on the Save Forces icon, located just under the sliders. There is also a Reload last saved forces icon which, in case you have made changes to your forces you do not like, will revert your settings to the previously saved settings. The Reset to default forces will reset all forces on the F1 to F4 keys to their default state. From the programming tab, you can mimic your controller to directly copy any of your keyboard commands that are used in your favorite games. The commands are then saved in what we call a Profile. When you click on the programming tab, you will be presented with a high-resolution image of the controller you are going to program on the left, and on the right side of the screen you will see a list of command boxes, called "Cells", going down the page. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected · Dans la fenêtre, sélectionnez Check this box to register now et suivez les instructions qui s'affichent à l'écran, vous pouvez aussi choisir de sélectionner cette option plus tard. Dans la fenêtre Registration, sélectionnez Check this box to register now et suivez les instructions qui s'affichent à l'écran, vous pouvez aussi choisir de ne pas sélectionner cette option et de vous enregistrer plus tard. Dans la fenêtre Registration, sélectionnez Check this box to register now et suivez les instructions qui s'affichent à l'écran, vous pouvez aussi choisir de sélectionner cette option plus tard. [. . . ]