User manual SAMSUNG AR18FSSSBWKN

[. . . ] CAUTION/WARNING SYMBOLS USED Indicates that a danger of death or serious injury exists. WARNING WARNING CAUTION Indicates that a risk of personal injury or material damage exists. OTHER SYMBOLS USED Explains terms to help users understand how use the product properly. NOTE 2_ Safety information Safety information IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, including the following: READ ALL INSTRUCTIONS BEFORE USING YOUR ROBOTIC VACUUM CLEANER. Unplug from outlet when not in use and before conducting maintenance. WARNING: to reduce the risk of fire, electric shock, or injury: GENERAL • Use only as described in this manual. • Do not operate the robotic vacuum cleaner or charger if it has been damaged in any way. [. . . ] It cannot be installed in the wrong direction. 6. Close the Dust bin cover and install it into the main unit. Maintain tools and filter _37 Maintain tools and filter CLEANING THE ROBOTIC VACUUM CLEANER CLEANING THE POWER BRUSH You must turn off the Power Switch at the bottom of the main unit before cleaning the robotic vacuum. ● Because the dust in the Dust bin may come out, CAUTION separate the Dust bin first before cleaning the power brush. 1. Separate the Dust bin by pressing the Dust bin Eject (PUSH) button. 2. After checking whether there are any foreign substances, press the hook that is fixing the brush cover to separate it. 3, Lift the power brush up from the main unit. 4. Remove any foreign substances such as long hairs or strings wrapped around the power brush using a cleaning brush or a vacuum cleaner. 5. When cleaning is complete, fix the Power Switch side of the power brush first and then fix the other side of the brush in the same way. 38_ Maintain tools and filter Maintain tools and filter CLEANING THE ROBOTIC VACUUM CLEANER 6. After inserting the 3 tips at the top of the cover, push the other end in until it “clicks” into place. 04 MAINTAIN TOOLS AND FILTER ● To prevent the robotic vacuum cleaner from becoming clogged, be careful not to CAUTION vacuum tooth picks or cotton swabs. ● When removing foreign substances become difficult, contact a customer care center. ● Because the power brush vacuums the dust on the floor, long strings or hair can become wrapped around the brush. Check and clean the power brush regularly. Maintain tools and filter _39 Maintain tools and filter CLEANING THE ROBOTIC VACUUM CLEANER CLEANING THE EDGE-CLEANING SIDE ROTATING BRUSH You must turn off the Power Switch at the bottom of the main unit before cleaning the robotic vacuum. 1. Check whether the side rotating brush is bent or whether there are any foreign substances stuck on the brush. 2. Wearing rubber gloves, wrap the side rotating brush with a cloth using hot water for about 10 seconds and wipe it on the cloth. 3. on the suction inlet. • Check whether the filter is • Clean the filter well. cleaner, and manually dock the robotic vacuum onto the charger to charge it. • Replace the batteries in the remote control. (AAA type) clogged. 42_ Troubleshooting Troubleshooting CHECKLIST BEFORE SVC CALLS SYMPTOM Robotic vacuum cleaner cannot find the charger. CHECKLIST • Check whether the power MEASURE TO TAKE plug of the charger is plugged correctly into the outlet. • If there are any obstacles within a range of about 1m in front of the charger and about 0. 5m range to the left and right of the charger, you should remove the obstacles. • If there are any foreign substances on the change pin, wipe them off with a dry towel. • Is the VIRTUAL GUARD installed near the charger? 05 TROUBLESHOOTING • Move the VIRTUAL GUARD to Robotic vacuum • Are the batteries of the VIRTUAL cleaner passes GUARD worn out?(OPTION) • Is the VIRTUAL GUARD set to Guard (virtual door) mode? • Is the Mode lamp turned off? another place so that the robotic vacuum cleaner can charge automatically. (2 type D (LR20) alkaline batteries) • Set the VIRTUAL GUARD to Fence (virtual wall) mode. • Check if the VIRTUAL GUARD is turned off and then set the VIRTUAL GUARD to a desired mode. • Are you using manganese drycell • Replace the batteries with new The battery usage time of the batteries?VIRTUAL GUARD (2 type D (LR20) alkaline is too short. [. . . ] EXCEPT WHEN OTHERWISE STATED IN WRITING THE COPYRIGHT HOLDERS AND/OR OTHER PARTIES PROVIDE THE LIBRARY “AS IS” WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE ENTIRE RISK AS TO THE QUALITY AND PERFORMANCE OF THE LIBRARY IS WITH YOU. SHOULD THE LIBRARY PROVE DEFECTIVE, YOU ASSUME THE COST OF ALL NECESSARY SERVICING, REPAIR OR CORRECTION. IN NO EVENT UNLESS REQUIRED BY APPLICABLE LAW OR AGREED TO IN WRITING WILL ANY COPYRIGHT HOLDER, OR ANY OTHER PARTY WHO MAY MODIFY AND/OR REDISTRIBUTE THE LIBRARY AS PERMITTED ABOVE, BE LIABLE TO YOU FOR DAMAGES, INCLUDING ANY GENERAL, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE LIBRARY (INCLUDING BUT NOT LIMITED TO LOSS OF DATA OR DATA BEING RENDERED INACCURATE OR LOSSES SUSTAINED BY YOU OR THIRD PARTIES OR A FAILURE OF THE LIBRARY TO OPERATE WITH ANY OTHER SOFTWARE), EVEN IF SUCH HOLDER OR OTHER PARTY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. [. . . ]