User manual SAMSUNG AW05M0YEA

[. . . ] Should this happen, switch off the breaker used for your air conditioner and contact your installation specialist. Make sure that the unit is correctly ventilated at all times: Do not place clothing or other materials over it. If the wireless remote control will not be used for a long time, remove the batteries. (If applicable) When using a wireless remote control, the distance should not be more than 7 meters from the air conditioner. [. . . ] 10 Technical Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 N INSTALLATION E-3 Description of Each Component Air outlet Inner air flow blades (right/left orientation) Outer air flow blades (up/down orientation) Air outlet Air inlet (Inside) Air inlet (Outside) Air filter (Inside) Adhesive bottom gasket (Refer to page 13) Power plug (The type of power plug may differ, depending on the local power supply. ) Thermostat control Operating mode selection dial E-4 Getting Started You have just purchased a Samsung window-type room air conditioner which should be installed following your Owner's Instructions. Your Owner's Instructions contain much valuable information on using your air conditioner. Please take the time to read them as they will help you take full advantage of the unit's features. The illustrations in the step-by-step procedures use four different symbols: PRESS PUSH IMPORTANT NOTE E-5 Cooling Your Room You must select the COOL mode if you wish to adjust the: N Cooling temperature N Fan speed when Cooling 1 Turn the operating mode selection dial and set it to " HI COOL " , " MED COOL " or " LOW COOL ". Result: N The air conditioner starts up in cool mode. N You can change modes at any time. 27°C ~ 23°C 2 Turn the THERMOSTAT control to the desired position. Possible temperatures: Can be set between 18°C and 29°C. Result: The air conditioner starts cooling, if the room temperature is higher than the selected temperature. 29°C ~ 27°C 23°C ~ 18°C 3 To control the direction of the air flow, refer to page 9. E-6 Switching the Air Conditioner Off You can switch the air conditioner off whenever you want. 1 To switch the unit off, simply set the operating mode selection dial to the " Off " position. Result: The air conditioner stops operating. Adjusting the Air Flow Direction Horizontally Depending on the position of the unit in your room, you can adjust the orientation of the inner air flow blades on the unit. Adjust the air flow blades to the desired position by pushing them side to side. E-7 Power Failure If a power failure occurs, the air conditioner is switched off. When the power comes back on, the air conditioner starts up again automatically. Temperature and Humidity Ranges The following table indicates the temperature and humidity ranges within which the air conditioner can be used. Mode Cooling Indoor Temperature 21°C to 32°C approx. Outdoor Temperature 21°C to 43°C approx. Indoor Humidity 80% or less If the air conditioner is used at. . . Higher temperature Lower temperature Then. . . The automatic protection feature may be triggered and the air conditioner stopped. A water leakage or some other malfunction may happen if the heat exchanger freezes. Higher humidity levels Water may condense on and drip from the surface of the unit if it is used for long periods. E-8 Cleaning Your Air Conditioner Be sure to clean the air filter periodically to maintain the air conditioner in the best condition for a long period of time. When cleaning the air conditioner, turn it off and pull out the power plug. 1 Open the front grille by pulling the tabs on both sides of the grille. Then lift it up slightly to open the front grille completely. 2 Grab the tabs on the filter and pull it up and out. 3 Remove all dust on the air filter with a vacuum cleaner or brush. 4 When you have finished, insert the air filter back into its original position. 5 Wipe the surface of the unit with a neutral detergent and then wipe it again with dry cloth. (Be sure not to use benzene, solvent or other chemical products. ) If you. . . Will not be using the air conditioner for a long period of time Then. . . N Set the fan going for a few hours to dry the inside of the air conditioner thoroughly. N Switch the air conditioner off and unplug it from the wall socket. [. . . ] Checkpoints prior to installation 1 Check the cabinet and front grille of the unit for any harmful defects such as scratches. 2 Be sure to check the power supply. - Refer to the specifications on the label attached to the unit. Installation Conditions 1 As the unit is heavy, the wall or window of the installation area should have sufficient strength and durability for operation of the air conditioner, and for prevention of any vibration or noise. If it is weak, reinforcement work should be performed separately. 2 It is advisable to install the air conditioner in the north or west side to prevent the effect of direct sunlight. When installing it in the south or east side due to unavoidable circumstances, it is advisable to install the sunshade to prevent the direct sunlight. [. . . ]