User manual SAMSUNG SC-8820

[. . . ] Close supervision is necessary when any appliance is used by or near children. Do not allow the vacuum cleaner to be used as a toy. Do not allow the vacuum cleaner to run unattended at any time. [. . . ] Don't cover the handle sender when you use a handle control button. 6_ operating the cleaner sender Handle Control The cleaner is controlled by using infrared signals. - bOdY Press the power ON/OFF button repeatedly to start and to stop the vacuum cleaner. (OFF ON OFF) If the remote handle control is not working, the cleaner can be operated using the ON/OFF button on the body of the machine. 1 02 OPERATING THE CLEANER 3 2 1 2 3 The ON/OFF button operates the vacuum cleanner or stops it. The INFRARED light indicates the part that receives the infra-red signal from the handle control. The filter light is illuminated when the dust pack requires checking or emptying. An audio signal will also sound. BODY-CONTROL TYPE (OPTIONAL) - hOSe To reduce suction for leaning draperies, small rugs, and other light fabrics, pull the tap air until the hole is open. - bOdY (VOlUme TYpe ONlY) To control power level, just slide the power control bottom right and left. mIN = For delicate fabrics, e. g. net curtains. mAX = For hard floors and heavily soiled carpets. operating the cleaner _7 maintain tools and filter USING ACCESSORY PIPE · Adjust the length of the telescopic pipe by sliding the length control button located in the center of the telescopic pipe back and forth. · To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube. ACCESSORY (OPTIONAL) · Push the accessory on to the end of the hose handle. · Pull out and turn the dusting brush for cleaning delicate areas. · To use the upholstery tool, push the accessory on to the end of the hose handle in the opposite direction. 8_ maintain tools and filter MAINTAIN FLOOR TOOLS 2-STEP BRUSH (OPTION) 03 MAINTAIN TOOLS AND FILTER Carpet Cleaning Floor Cleaning · Adjust the inlet lever according to the floor surface. · Remove waste matter completely if the inlet is blocked. POWER PET PLUS BRUSH (OPTION) 1 2 3 For improved pickup of pet hair and fibre on carpets. 4 5 6 Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. Push the Open button of the transparent screen cover to separate the cover. Remove the brushbar from the transparent screen. Remove waste matter such as dust and hair tangled around the brushbar using scissors. Remove dust inside the brush housing using a dry duster or crevice tool. Insert brushbar into rotating belt and assemble. Click the transparent screen cover back into place to reassemble. PARQUET MASTER BRUSH (OPTION) · Vacuum dust in wide area at once. · Remove waste matter completely if the inlet is blocked. maintain tools and filter _9 maintain tools and filter PET BRUSH (OPTION) For improved pick-up of pet hair and fibre on carpets. Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. [. . . ] Dispose of the batteries property. BATTERY TYPE : AAA Size 14_ maintain tools and filter troubleshooting pROblem Motor does not start SOlUTION · Check cable, pulg and socket. · Leave to cool. 04 TROUBLESHOOTING Suction force is gradually · Check for blockage and remove. decreasing Cord does not rewind fully · Pull the cord out 2-3m and push down the cord rewind button. Vacuum cleaner does not · Check hose and replace if required. [. . . ]