User manual SAMSUNG CTR164NB01

[. . . ] CTR164TB Series CTR164EB Series CTR164NB Series CTR164DB Series CTR164AB Series CTR164KB Series Ceramic Glass Hob user manual imagine the possibilities Thank you for purchasing this Samsung product. To receive more complete service, please register your product at ENGLISH www. samsung. com/register This manual is made with 100% recycled paper. CTR164NB01_XSA_00340A-EN. indd 1 2011-01-19 4:10:04 using this manual Please take the time to read this owner's manual, paying particular attention to the safety information contained in the following section, before using your appliance. If transferring ownership of the appliance, please remember to pass the manual on to the new owner. IMPORTANT SAFETY SYMBOLS AND PRECAUTIONS. The following symbols are used in the text of this Owner's Manual : WARNING CAUTION CAUTION Hazards or unsafe practices that may result in severe personal injury or death. Hazards or unsafe practices that may result in minor personal injury or property damage. [. . . ] With respect to fire protection, this appliance corresponds to EN 60335 - 2 - 6. This type of appliance may be installed with a high cupboard or wall on one side. Drawers may not be fitted underneath the hob. The installation must guarantee shock protection. The kitchen unit in which the appliance is fitted must satisfy the stability requirements of DIN 68930. For protection against moisture, all cut surfaces are to be sealed with a suitable sealant. On tiled work surfaces, the joints in the area where the hob sits must be completely filled with grout. On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place with a suitable artificial resin or mixed adhesive. Ensure that the seal is correctly seated against the work surface without any gaps. Additional silicon sealant must not be applied; this would make removal more difficult when servicing. The hob must be pressed out from below when removed. A board is to be installed underneath the hob. The surface temperature on the underside of the electric hob may exceeds 95°C. To avoid hazard, under bench access must be restricted. · · · · · · · · · · CAUTION 12_ installing the hob CTR164NB01_XSA_00340A-EN. indd 12 2011-01-19 4:10:05 CONNECTING TO THE MAINS POWER SUPPLY Before connecting, check that the nominal voltage of the appliance, that is, the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. The heating element voltage is AC 230 V~. The appliance also works perfectly on networks with AC 220 V~ or AC 240 V~. The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. automatic line protecting cut - out, earth leakage trips or fuse. A type H05RN - F cable or one of a higher grade must be used as the mains connecting cable. Rated current of appliance (A) 1N~ 2N~ > 25 and 32 > 10 and 16 Nominal cross-sectional area (mm2) 2. 5 1. 5 WARNING Shut off power to circuit before connecting wires to circuit. INSTALLING THE HOB The connection must be carried out as shown in the diagram. The connecting links should be fitted according to the appropriate connection diagram. [. . . ] · The control indicators in the control panel are illuminated. · The cooking zone is switched on. · The cooking zones are set at the desired heat settings. What should I do if the cooking zones will not switch on? Check for the following possibilities: · A period of more than 10 seconds has elapsed between when the On/Off button was actuated and the desired cooking zone switches on (see the section "Switching the appliance on"). · The control panel is partially covered by a damp cloth or liquid. What should I do if the display except for indicator suddenly disappears? the residual warmth This could be a result of one of two possibilities: · The On/Off sensor was accidentally actuated. [. . . ]