User manual SAMSUNG DV405ETPASU/AC

[. . . ] · Use this appliance only for its intended purpose as described in this Owner's Manual. - This dryer must be properly installed and located in accordance with the Installation Instructions before it is used. - Properly ground to conform with Local Codes. Follow details in Installation Instructions. [. . . ] · Do not assemble the duct work with fasteners that extend into the duct. They will serve as a collection point for lint. · Duct joints can be made air and moisture-tight by wrapping the overlapped joints with duct tape. INSULATION · Duct work which runs through an unheated area or is near an air conditioning duct, should be insulated to reduce condensation and lint build up and be sloped down toward outdoors. NOTE: Never install screen inside exhaust duct. WARNING: THE DRYER MUST EXHAUST TO THE OUTDOORS. TO PREVENT LARGE AMOUNTS OF LINT AND MOISTURE FROM ACCUMULATING AND TO MAINTAIN DRYING EFFICIENCY, THIS MACHINE MUST BE EXHAUSTED OUTDOORS. SAMSUNG Clothes Dryers Owner's Instructions 4 Installation Instructions EXHAUST LENGTH CALCULATION Table 1: RECOMMENDED MAXIMUM LENGTH ELECTRIC DRYERS Weather Hood Type Recommended Use only for short run installations 4"(10. 16cm) No. of 90° elbows 2 1/2"(6. 35cm) Rigid 14m(46ft. ) 11m(38ft. ) 9m(31ft. ) 7m(24ft. ) Metallic Flexible* 9m(30ft. ) 7. 5m(25ft. ) 6m(20ft. ) 5m(16ft. ) Rigid 11m(37ft. ) 9m(30ft. ) 6. 5m(22ft. ) 4. 5m(15ft. ) Metallic Flexible* 7m(24ft. ) 6m(20ft. ) 4m(14ft. ) 3m(10ft. ) 0 1 2 3 * Do not use non metallic flexible duct. EXHAUST DIRECTIONS All dryers shipped from the factory are set up for rear exhausting. However exhausting can be on the right or left side of the cabinet or the bottom of the dryer. · · · · · Remove access panel at back of dryer to gain access to internal ducts. Disconnect duct exhaust from blower housing. Remove desired knockout plate (either right or left side). TIME button Initial time mode of TIME button displays 50 minutes. Push TIME button continuously to change time as follows: 50 minutes 40 minutes 30 minutes 20 minutes 50 minutes 2. TEMPERATURE button Initial mode is set to OFF at the factory. Push TEMPERATURE button to select LOW temperature and turn the lamp ON. PROGRAM button Initial mode displays CUP BOARD. Push PROGRAM button each time to change the mode as follows: Cupboard Iron Rotary Iron Extra Cupboard 4. COURSE button Initial mode displays COTTON. Push the button to change the mode as follows: Cotton Synthetics Cotton 5. FILTER lamp Turn the system ON to let FILTER lamp flicker 3 times. When a drying cycle is finished, FILTER lamp turns ON to display cleaning instruction of filter. CHILD LOCK lamp When the system turns ON, push Wrinkle-Free button and DELAY START button in order to turn CHILD LOCK lamp ON. [. . . ] Do not mix heavy, hard-to-dry items with lightweight articles. · Large loads of moisture-holding fabrics, such as beach towels, take a long time to remove moisture. If drying only one article, add two more similar articles, even if dry, to ensure proper tumbling. · Some fabrics will shrink whether machine washed and tumble dried or washed by hand and drip dried; others may be safely washed but will shrink in a dryer. [. . . ]