User manual SAMSUNG DV422GWHDWR

[. . . ] Imagine the possibilities Thank you for purchasing this Samsung product. To receive more complete service or accessory parts, please register your product at or contact www. Extra Large Capacity Ultra drying capabilities are at your fingertips!Ft(DV422*, DV400*) capacity dryer circulates more air through your clothes, drying them faster, for a wrinkle-free result. [. . . ] The dryer frame is grounded to the neutral conductor at the terminal block. A 4-WIRE SYSTEM CONNECTION is required for new or remodeled construction, mobile homes, or if local codes do not permit grounding through neutral. If you use the 4-wire system, you cannot ground the dryer frame to the neutral conductor at the terminal block. Insert the power cord with a UL-listed strain relief through the hole provided in the cabinet near the terminal block. Do not loosen the nuts already installed on the terminal block. Use a 3/8” (1cm) deep well socket. For instructions, go to Connecting the Inlet Hose on page 10. To ensure that the dryer provides optimal drying performance, it must be level. To level the dryer, follow the lettered steps below: a. Using a level, check if the dryer is level side to side and then front to back. If the dryer is not level, adjust the leveling feet on the bottom of the dryer until the washer is level side to side and back to front. Turning the feet clockwise retracts the feet. turning the feet clockwise loosens and extends them. To set the dryer to the same height as the washer, fully retract the leveling feet by turning them counterclockwise, then loosen the feet by turning them clockwise. Once the dryer is the same height as the washer, follow the directions above to level the dryer. Leveling feet Level Retract fully Then loosen Adjust the leveling feet only as much as necessary to level the dryer. Extending the leveling feet more than necessary can cause the dryer to vibrate. Make sure all gas connections (on gas models), exhaust, and electrical connections are complete. Plug in your dryer, and then check its operation by using the checklist below. For GAS MODELS ONLY The burner may not ignite initially due to air in the gas line. Allowing your dryer to operate on a heat setting will purge the line. If the gas does not ignite within 5 minutes, turn your dryer off and wait 5 minutes. [. . . ] * For best results, follow the load size recommendations for each dry cycle. (SAMSUNG) and delivered new, in the original carton to the original consumer purchaser, is warranted by SAMSUNG against manufacturing defects in materials and workmanship for a limited warranty period of: One (1) Year All Parts and Labor Two (2) Years Control Board Parts This limited warranty begins on the original date of purchase, and is valid only on products purchased and used in the United States. To receive warranty service, the purchaser must contact SAMSUNG for problem determination and service procedures. warranty service can only be performed by a SAMSUNG authorized service center. [. . . ]