User manual SAMSUNG MWR-SH00

[. . . ] Do not install the remote control in a location where Do it will come into contact with the combustible gases, machine oil, sulphide gas, etc. not press buttons with a pointed thing. Do not pull or bend the wired remote control cable Do excessively. not use this wired remote control for other purpose. [. . . ] The illustrations in the step-by-step procedures use 3 different symbols: PRESS PUSH HOLD DOWN E-5 Selecting the Auto Mode The room temperature and the fan speed are controlled automatically in the Auto mode. 1 Press the (ON/OFF) button to turn on the indoor unit. (Do not press the (ON/OFF) button if the remote control is on). Result: T he air conditioner will be turned on with the mode selected when the unit was last used. The air conditioner has a built-in protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped The air conditioner will start up after 3 minutes. button until is Caution 2 To select the Auto mode, press the displayed on the remote control. Result: The air conditioner will run in Auto mode. 3 To adjust the temperature, press the buttons to set the desired temperature. The temperature can be set between 18°C(65°F) and 30°C(86°F). Result: The temperature is adjusted by 1°C(1°F) when the buttons are pressed. E-6 Selecting the Cool Mode Select the Cool mode to lower the room temperature. 1 Press the (ON/OFF) button to turn on the indoor unit. (Do not press the (ON/OFF) button if the remote control is on). Result: T he air conditioner will be turned on with the mode selected when the unit was last used. The air conditioner has a built-in protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped The air conditioner will start up after 3 minutes. button until is Caution 2 To select the Cool mode, press the displayed on the remote control. Result: The air conditioner will run in Cool mode. 3 To adjust the temperature, press the buttons to set the desired temperature. The temperature can be set between 18°C(65°F) and 30°C(86°F). Result: The temperature is adjusted by 1°C(1°F) when the buttons are pressed. The air conditioner will start cooling if the temperature set is lower than the room temperature. The fan will run even if the temperature set is higher than the room temperature. 4 To adjust the fan speed, refer to page 11. The Cool and Heat mode cannot be selected at the same time. Note E-7 Selecting the Heat Mode The Heat mode can be selected only on the heat pump models. Select the Heat mode to raise the room temperature. 1 Press the (ON/OFF) button to turn on the indoor unit. (Do not press the (ON/OFF) button if the remote control is on). Result: T he air conditioner will be turned on with the mode selected when the unit was last used. The air conditioner has a built-in protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped The air conditioner will start up after 3 minutes. button until is Caution 2 To select the Heat mode, press the displayed on the remote control. [. . . ] Under this circumstance, the air conditioner defrosts by itself to increase the efficiency and save energy. ou can not activate the Deice mode because it is activated Y automatically and just displayed on the wired remote control. hough you change the operation mode before the T defrosting is completed, the Deice mode indicator is on until the air conditioner finishes the operation. The Deice mode indicator is off after the air conditioner completes defrosting. Adjusting the Fan Speed Change the fan speed fit in your circumstances. 1 Press the (ON/OFF) button to turn on the indoor unit. [. . . ]