User manual SAMSUNG NP700Z7CH

[. . . ] • Warnings and Important Safety Instructions in this manual do not cover all possible conditions and situations that may occur. It is your responsibility to use common sense, caution, and care when installing, maintaining, and operating your appliance. • Because these following operating instructions cover various models, the characteristics of your refrigerator may differ slightly from those described in this manual and not all warning signs may be applicable. If you have any questions or concerns, contact your nearest service center or find help and information online at www. samsung. com. [. . . ] If you need help, review the previous section on levelling the refrigerator. When the door of the freezer is higher than the fridge 01 SETTING UP When the Freezer door is lower than the fridge Insert a flat-blade screwdriver into a notch on the Leg, turn it clockwise or counter clockwise to level the freezer. Adjustment part In the process for adjusting both the doors is the same. Open the doors and adjust them, one at a time, as follows: 1. Unscrew the nut 1 from the lower hinge until it reaches the upper end of the bolt 2 . 3 1 Wrench 2 Nut Bolt Leg Screw Driver When the Freezer door is higher than the fridge Insert a flat-blade screwdriver into a notch on the Leg, turn it clockwise or counter clockwise to level the fridge. When you release the nut 1 , make sure that you use the Allen wrench provided 3 to loosen the bolt 2 in a counter-clockwise direction. You should then be able to unscrew the nut 1 with your fingers. Adjust the height difference between the doors by turning the bolt 2 clockwise or counter clockwise 3 2 Wrench Bolt . , the door will Leg Screw Driver When you turn clockwise move up. Refer to the next section for the best way to make very minor adjustments to the doors. 3. After adjusting 3 Wrench the doors, turn the nut 1 2 Bolt clockwise 1 Nut until it reaches the lower end of the bolt, then tighten the bolt again with the wrench 3 to fix the nut in place 1 . If you do not secure the nut firmly, the bolt may release. setting up _11 DA99-02318A(0. 7). indd Sec4:11 2012. 2. 8 4:38:36 PM CHECKING THE WATER DISPENSER LINE (OPTIONAL) A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote better health, the Samsung water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. Follow these instructions carefully to minimise the risk of expensive water damage. Note: If the coupler does not fit on the current tap, go the nearest authorised service dealer and purchase the right couplers fittings. select the location where the purifier is to install. (Model with the purifier) - If you wish to reassemble the water inlet and outlet sides of the purifier during purifier installation, see the reference illustration. - Cut the water line attached to the purifier to the appropriate place after measuring the distance between the purifier and the cold water tap. setting up _13 DA99-02318A(0. 7). indd Sec4:13 2012. 2. 8 4:38:41 PM COUPLER “A” Remove any residual matter inside the purifier. (Model with the purifier) - Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifier. - If water does not come out through the line, check whether the tap is open. - Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed. OUTLET SIDE OF PURIFIER PURIFIER TAP LINE OUTLET SIDE OF PURIFIER 90 degree CAUTION PURIFIER WATER Insert Locking Clip After tube seated WATER WATER INLET SIDE OF PURIFIER COUPLER Locking Clip WATER LINE Replacement Instructions 1. Insert water supply tube into the inlet side of the filter until the tube stop. FLOW DIRECTION Attach the purifier lock-clip. - Hold the purifier lock-clip in the appropriate position (under the sink for example) and fix it tightly into place where to screw. WATER SUPPLY INLET SIDE PERMEAT PURIFIER LOCK-CLIP Note : You must also ensure that the cut is square and not at any sort of angle as this could cause a leak Secure the purifier in position. - Fix the purifier in position, as shown in the figure on the right. WATER TUBE PURIFIER LOCK-CLIP PURIFIER 4. After inserting tube, put together the clip strongly. If leaks persist, discontinue use and call your supporting dealer. Flush filter for 5 minutes before use. 14_ setting up DA99-02318A(0. 7). indd Sec4:14 2012. 2. 8 4:38:42 PM Connect the water line to the refrigerator. - Remove the compressor cover of the refrigerator. - Connect the water line to the valve, as shown in the figure. [. . . ] Some heat is normal as anti-condensators are installed in the front corners of the refrigerator to prevent condensation. Condensation can occur when you leave the door open for a long time. Did you wait for 12 hours after installation of the water supply line before making ice?Is the water line connected and the shut-off valve open? [. . . ]