User manual SAMSUNG NS071NDXEA

[. . . ] Contents PREPARATION Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Name of Each Part . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Remote Control ­ Buttons and Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Inserting the Remote Control Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The inner blades with small fins move the air in the desired direction. 1 Adjust the inner blades by moving them left or right. Make sure do not touch the inner blades during operation. It may cause injury on your fingers. E-19 Setting the On Timer The On Timer enables you to turn on the air conditioner automatically at the appointed time within a range of 30 minutes to 24 hours. 1 Press Result: button. is blinking on the remote control display. 2 Press Result: button to set until the desired time is displayed. Time is adjusted for 30 minutes or 1-hour increments pressing button within a range of 30 minutes to 24 hours. 3 Press Result: button to complete setting. Blinking stops and remaining time is displayed. button in 10 seconds, setting will be again. If you don't press canceled. To cancel the set, press 4 Press display. Result: button until the desired mode appears on the remote control The air conditioner runs in the selected mode when it is turned on. Whenever pressing button, Auto Cool Dry Fan Heat is selected repeatedly. 5 To adjust the temperature, press button to set the desired temperature. Result: Press button until the desired temperature appears on the remote control display. Adjusting temperature is in Auto, Cool, Dry and Heat mode. E-20 Setting the Off Timer ENGLISH The Off Timer enables you to turn on the air conditioner automatically at the appointed time within a range of 30 minutes to 24 hours. 1 Press Result: button. is blinking on the remote control display. 2 Press Result: button to set until the desired time is displayed. Time is adjusted for 30 minutes or 1-hour increments pressing button within a range of 30 minutes to 24 hours. 3 Press Result: button to complete setting. Blinking stops and remaining time is displayed. button in 10 seconds, setting will be again. If you don't press canceled. To cancel the set, press Note If you would like to turn off the air conditioner and then to turn on it again automatically at the appointed time by using On/Off Timer, you should set Off Timer longer than On Timer. If you press button when On and Off Timer are set at once, both settings will be canceled. E-21 Operating Your Air Conditioner Without the Remote Control Your air conditioner can be operated directly from the indoor unit if the remote control is lost or broken. 1 To switch the air conditioner on, press the ON/OFF switch on the right side of the indoor unit. Result: The OPERATION indicator on the indoor unit comes on. The air conditioner starts up in the most suitable mode for the room temperature. The mode may change from cooling into heating, from heating into cooling depending on the current temperature during operation: Room Temperature Operating Mode Less than 24°C Heat 24°C or above Cool 2 To switch the air conditioner off, press the ON/OFF switch again. Note Even if the air conditioner has been switched on via the ON/OFF switch, operations can still be controlled using the remote control as usual. E-22 Cleaning Your Air Conditioner ENGLISH To get the best possible use out of your air conditioner, you must clean it regularly to remove the dust that accumulates on the air filter. Before cleaning your air conditioner, ensure that you IMPORTANT have switched off the breaker used for the unit. 1 Open the upper front grille by pulling the lower right and left tabs of the grille. 2 Pull air filters out of each tab of the grille. 3 Remove all dust on the air filters with a vacuum cleaner or brush. 4 When you finished, insert air filters by fixing it to each tab of the grille. [. . . ] Check if the air filter is blocked by dirt. Check if the there is cover on the outdoor unit or any obstacle. Check if you installed the air conditioner under direct sunlight. Check if you turn on the air conditioner just now. [. . . ]