User manual SAMSUNG S24C350HL

[. . . ] 3-13 INSTALLING THE SOFTWARE Natural Color . 4-3 TROUBLESHOOTING Monitor Self-Diagnosis . 5-3 MORE INFORMATION Specifications . 6-19 Correct Disposal of This Product (Waste Electrical & Electronic Equipment) - Europe only . [. . . ] Off: If you press and hold the MENU button down for 5 seconds again, the OSD Adjustment Lock function is disabled. Even if the OSD Adjustment Lock function is activated, users can adjust the brightness and contrast and can set up the adjustment function assigned to the [ ]. Users can set the <Customized Key> to one of the following functions. If the user presses the Customized Key [ ] after setting it, the configured function will be performed · < Angle> - < Bright> - <Eco Saving> - <Image Size> You can set the function of the Customized Key by selecting <SETUP&RESET> -> <Customized Key> in the OSD. / Use these buttons to navigate the menu or to adjust a value in the OSD. Use this button to control the brightness of the screen. Using the product 3-12 ICON Use this button to select a function. If you press the [ DESCRIPTION ] button when there is no OSD, the input signal (Analog/Digital) is switched. When the input signal is switched by pressing [ ] button or the product is turned on, a message displaying the selected input signal appears at the top left of the screen. This function is not available for products with an Analog interface only. AUTO Press [AUTO] button to adjust the screen settings automatically This function is only available in Analog mode. If the resolution settings are changed in the Display Properties, the AUTO adjustment function is performed. This menu is unavailable when < Bright> is set to <Dynamic Contrast> or <Cinema> Color> is set. Removes vertical noise lines (line pattern) from the screen. Coarse The location of the screen may be changed after the adjustment. In this case, move the screen so that the screen is displayed at the center of the display panel using the <H-Position> menu. This function is only available in Analog mode. Removes horizontal noise lines (line pattern) from the screen. Fine If you cannot remove the noise completely with the <Fine> function, adjust the <Coarse> and then use the <Fine> function again. This function is only available in Analog mode. Using the product 3-13 COLOR Menu Description Expresses natural colors more clearly without changing the picture quality using proprietary digital picture quality improvement technology developed by Samsung Electronics. · <Off> - Turns the < Color> function off. Color> with the original pictures. Color · · · <Demo> - You can compare the pictures processed by < <Full> - Provides a clearer picture including areas corresponding to skin color. <Intelligent> - Improves the chroma of pictures except for areas corresponding to skin color. This menu is unavailable when < Angle> is set. You can adjust the red color value of pictures according to your preference. [. . . ] Use the software utility installed on your computer to set up this feature. STATE Power Indicator Power Consumption NORMAL OPERATION On 27 W POWER SAVING MODE Blinking Typical 0. 3 W POWER OFF Off Typical 0. 3 W If there is no power cut-off switch, the power consumption is "0" only when the power cord is disconnected. More Information 6-14 6-15 Specifications MODEL NAME Panel Size Display area Pixel Pitch Synchronization Display Color Resolution Optimum resolution Maximum resolution Horizontal Vertical 23. 6 inches (59 cm) 521. 28 mm (H) x 293. 22 mm (V) 0. 2715 mm (H) x 0. 2715 mm (V) 30 ~ 81 kHz 56 ~ 75 Hz 16. 7 M 1920x1080 @ 60 Hz 1920x1080 @ 60 Hz RGB Analog, DVI(Digital Visual Interface) Compliant Digital RGB Input Signal, Terminated 0. 7 Vp-p ± 5% separate H/V sync, Composite, SOG TTL level (V high 2. 0V, V low 0. 8V) Maximum Pixel Clock Power Supply Signal Cable 164MHz (Analog, Digital) This product supports 100-240 V. Since the standard voltage may differ from country to country, please check the label on the back of the product. 15pin-to-15pin D-sub cable, Detachable DVI-D to DVI-D connector, Detachable Dimensions (WxHxD) / Weight 569 x 342 x 53 mm (22. 4 x 13. 5 x 2. 1 inches) (Without Stand) 569 x 416 x 197 mm (22. 4 x 16. 4 x 7. 8 inches) (With Stand) / 3. 8 kg (8. 4 lbs) Environmental considerations Operating Operating Temperature : 50°F ~ 104°F (10°C ~ 40°C) Humidity :10 % ~ 80 %, non-condensing Storage Storage Temperature : -4°F ~ 113°F (-20°C ~ 45°C) Humidity : 5 % ~ 95 %, non-condensing Tilt 0°( ±2°) ~20°( ±2°) S24A300BL Design and specifications are subject to change without prior notice. Class B (Information Communication equipment for residential use) This device is registered for EMC requirements for home use (Class B). [. . . ]