User manual SAMSUNG SMH2117S/XAC INSTALLATION GUIDE INSTALLATION MANUAL

[. . . ] Installation Instructions Over The Range Microwave Oven BEFORE YOU BEGIN (Read these instructions completely and carefully. ) IMPORTANT IMPORTANT Save these instructions for local inspector’s use. observe all governing codes and ordinances. -  e sure to leave these instructions with the Consumer. [. . . ] Then carefully roll the oven and carton over onto the top side. The oven should be resting in the Styrofoam. Find the studs using one of the following methods: A. After locating the stud(s), find the stud’s center by probing the wall with a small nail to find the edges of the stud. Then, place a mark halfway between the edges. The center of any adjacent studs should be 16˝ or 24˝ from this mark. Draw a line down the center of the studs. Remove the 2 screws from the mounting plate. This plate will be used as the rear wall template and for mounting. NOTE: You will have to reuse two screws in original loction of outcase after removing mounting plate. Determining wall plate location under your cabinet Plate position – beneath flat bottom cabinet. plate position – beneath framed recessed cabinet bottom. 16 ½˝ C L At least 30˝ s Draw a vertical line on the wall at the center of the 30˝ wide space. Tape the Rear Wall Template onto the wall so that the top of the template touches the bottom of the cabinet and the centerline on the template lines up with the line you drew on the wall. C L 30˝ to Cooktop Draw a vertical line on the wall at the center of the 30˝ wide space. Tape the Rear Wall Template onto the wall so that the top of the template touches the bottom of the cabinet frame and the centerline on the template lines up with the line you drew on the wall. T Plate position – beneath recessed bottom cabinet with front overhang. Your cabinets may have decorative trim that interferes with the microwave installation. Remove the decorative trim to install the microwave properly and to make it level. Use a level to make sure the cabinet bottom is level. Draw a vertical line on the wall at the center of the 30˝ wide space. Draw a second, horizontal line on the wall below the cabinet to mark how far the inside of the front overhang descends below the cabinet. [. . . ] Keep it tight throughout Steps 1–3. Do not pinch the cord or lift the oven by pulling cord. Lift the microwave, tilt it forward, and hook the slots at the back bottom edge onto the four lower tabs of the mounting plate. Use the top cabinet template to prepare the top cabinet You need to drill holes for the top support screws and a hole large enough for the power cord to fit through. [. . . ]