User manual SAMSUNG SU8860

[. . . ] SU88 SERIES Vacuum Cleaner user manual Before operating this unit, please read the instructions carefully. For indoor use only. English imagine the possibilities Thank you for purchasing a Samsung product. To receive a more complete service, please register your product at www. samsung. com/register Safety Information SAFETY INFORMATION · Before operating the appliance, please read this manual thoroughly and retain it for your reference. · Because these following operating instructions cover various models, the characteristics of your vacuum cleaner may differ slightly from those described in this manual. WARNING WARNING CAUTION/WARNING SYMBOLS USED WARNING Indicates that a danger of death or serious injury exists. [. . . ] If this happens, turn switch off and unplug the cleaner. Inspect the inlets, hose, diverter, and filters for any blockages, and then empty the dust bin and clean filters. The performance Indicator lights up red when the dust bin and filters require checking or emptying. Before the performance indicator lights up red, the dust bin needs to be emptied when the dirt reaches the "MAX" line on the side of it, then the suction power and filter maintenance cycles will be prolonged. operating the cleaner _9 Operating the cleaner ThERMAl PROTEcTOR This vacuum cleaner has a thermal protector which automatically trips to protect the vacuum cleaner from overheating. If a clog prevents the normal flow of air to the motor, the thermal protector turns the suction motor off automatically. This allows the suction motor to cool in order to prevent possible damage to the vacuum cleaner. Turn off and unplug vacuum cleaner to allow the vacuum cleaner to cool and the thermal protector to reset. Check for and remove clogs, if necessary. Also check and replace any clogged filters. Wait approximately 1 hour and plug the vacuum cleaner in and turn back on to see if the suction motor protector has reset. CAUTION Even though the suction motor is shut off, the floor brush may not stop. Turn off the brush roll switch before inspecting the cleaner. Do not power on without the dust bin and the exhaust filter in their place. Otherwise, the suction motor will be shut off because of the thermal protector to protect the vacuum cleaner from overheating. If this happens, turn off the switch and unplug the cleaner to allow the vacuum cleaner to cool. Wait approximately 1 hour and plug the vacuum cleaner in and turn back on to see if the suction motor protector has reset. OVERlOAD PROTEcTOR The overload protector shuts off the brush motor if the floor brush becomes obstructed. The floor brush will stop, but the suction motor will continue to run. To reset the overload protector, turn the cleaner off and unplug it. Clear the obstruction from the floor brush area. Use a pen tip to press down the reset switch. Do not put the your vacuum cleaner above you when cleaning the stairs. Always use vacuum from the bottom of the staircase and ensure that the vacuum remains securely flat on the fioor surface. CAUTION Always keep hair, loose clothing, fingers, and all parts of body away from brush roll area while cleaner is on. cARRYING hANDlE (DUST bIN hANDlE) Special handle for comfortable carrying from room to room or up and down stairs. CAUTION Carrying Handle (Dust bin handle) Dust Bin Release Button When you carry the vacuum cleaner, please do not push the `Dust Bin Release Button'. [. . . ] Inspect belt to ensure that it is in good condition. If, belt is broken or cracked, replace belt according to 'Replacing Belt' instructions. Unscrew the four screws on the back of the pop-up brush to remove the bottom place and clean string, hair, and other debris from shaft pulley and belt areas. Insert the four tabs on edge of brush cover and snap closed. [. . . ]