User manual SANGEAN PR-D7

[. . . ] Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. To reduce the risk of fire or electric shock, Do not expose this appliance to Rain or Moisture. Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, shall not be placed on the apparatus. Remove the battery cover on the back of the unit by sliding the cover in the direction of the arrow. [. . . ] Press and hold the button for more than 2 seconds, display will flash time set symbol and also the hour digit, followed by a beep. This radio is equipped with three tuning methods ­ Scan tuning, Manual tuning and Memory presets recall. Press and release Scan button ( long press Scan button more than 2 seconds will activate time setting ), the radio will up search and stop automatically when it finds a radio station with good signal. Press the Scan button again to pick up the found station. The radio will continue to search next available stations if you do not press Scan button again when it finds a radio station. Rotate the Volume Control to get required sound level. A single press on either the Tuning Up or Down button will change the frequency in the following increments: FM: 50 or 100 kHz AM (MW): 9 or 10 kHz 4. Press and hold either Tuning Up or Down button until the frequency in the display begins to change rapidly. Your radio will search the selected waveband and stop automatically when it finds a station of sufficient signal. Rotate the Volume control to get required sound level. There are 5 memory presets for each waveband. Press and hold down the required preset until the radio beeps. Stations stored in preset memories can be overwritten by following above procedures. When the radio alarm is selected, the radio will turn on and play the chosen radio station at the chosen alarm time. The radio alarm will continue for an hour unless turned off by pressing the Power button. press the Power button whilst the alarm is activated will cancel the alarm for 24 hours. Note: Radio alarm can be activated only until both radio alarm time and radio alarmed station are set. Radio alarm will be automatically switched to buzzer alarm when the radio is in low battery status or the selected radio alarm station signal is too weak. The radio alarm can be set either radio is on or off. Press button for more than 2 seconds followed by a beep. Display Hour will flash, using Tuning Up/Down button to select the hour then press button again to confirm hour setting. Follow same procedures of setting hour to set required minute. [. . . ] by pressing Tuning Up/Down button , you may adjust to 100 kHz per tuning step. After FM tuning step is reset, pressing Band/Step button again, display will show MW and flash 9 kHz. After FM/MW tuning step is reset, display will flash 12H, press Tuning Up/Down to select 24 Hour format, complete the setting by pressing Band/Step button. 5 mm headphone socket located on the left hand of your radio is provided for use with either headphones or an earpiece. [. . . ]