User manual SANGEAN PT-80

[. . . ] To ensure that this device provides you with long-term satisfaction and enjoyment, please observe the following instructions. this device is designed for the playback of audio signals. Protect the device from moisture (water drops or splashes). Do not place any vessels such as vases on the device. [. . . ] ­ Display: » M 1 « and the preset number, for example » Press » FREQ. The short wave band is divided into frequency bands of different lengths. This means that very many stations and institutions use this wave band for international communication. Therefore, you can store up to 18 SW stations on two memory levels. 1 2 Save short wave stations in the same way as described in the previous section. Once you have stored nine stations on one memory level » M 1 «, press »SW PAGE CLOCK 1/2« to switch to the second memory level. Note: If you try to store more than 18 stations and press »MEMO AM/PM«, »FULL« appears in the display. This function allows you to automatically search for and store nine stations in each of the FM, MW and LW bands (not SW). 1 To start the search, press » « and » « at the same time and hold them down until you hear a signal. ­ The search starts at the lowest frequency in the selected wave band, and stores the nine stations with the strongest signals. After the search has finished, a signal sounds and the last station stored can be heard. ­ Display: » M 1 « and the preset number, for example » «. Notes: When you start the search, all the previously stored stations are deleted. During the search, the status line » . « shows the progress, but not the stations found. You can stop the search by pressing »ON/OFF«. You can reorganise the preset stations using MODE 50 or 51 (see page 16). ­ Display: the frequency and the preset number, for example » Press »MEMO AM/PM«. Note: If the radio is switched off, press »DISPLAY« to switch the display to the clock, and start at step 1. ­ Display: the alarm time you entered, » « or » « stay lit. If you select short wave, you can select the frequency band by pressing »SW SELECT«. ­ Display: the frequency and the preset number, for example » «. [. . . ] « LED lights up ­ If an SSB station is received, the »TUNE/SSB orange. Enter the alarm time using the numerical buttons »1 . The signal tone increases in volume for one minute, stops for a minute and starts again. Enter the alarm time using the numerical buttons »1 . [. . . ]