User manual SANGEAN RCR-2

[. . . ] Only use attachments/accessories specified by the manufacturer. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. [. . . ] symbol indicating the time is under D. S. T. DATE Press DATE button, display DATE will blink. Press SET button, display will blink year with a beep and a small Y (year) will appear, 1. Press SET button again and follow the setting of year to set the month and date . Confirm DATE setting by pressing DATE button again. Now the display will show time, date, week day, second and symbol . You can always adjust the time manually whenever is required by following above procedures. GB 10 Radio operation Turn on the radio with the Power on/off key 1. Tune into desired stations Manual station selection 1. With the key 15 Tuning + and -, you can tune into the frequency of your desired stations. Scanning tuning Press and hold key 15 + or ­ for more than 0. 5 seconds and release, the radio will search for the next station. Storing the preset stations Tune into the stations. Select a memory preset button and press for more than 2 seconds until a confirmed beep sounds and display M stops blinking. Note: When you store a new station in a memory slot, the station previously in that slot is automatically erased. Recall the station memories Recall the station memories, simply select the required bands and press required station memory slot buttons 1-7. Volume You can select the required volume by adjusting the Volume control button 18. 11 Alarm Clock Alarm setting can be done while the appliance power is during on or off position. The alarm clock is equipped with two alarm systems which can be operated independently of each other either with Human Wake System buzzer or with a radio (radio alarm clock ). Select the desired station by station memory button 1-7 or simply tune the radio station. Select alarm system 1 or 2 by pressing the alarm 1 or 2 button. Display will blink selected alarm system symbol. Press alarm SET button 13, display will blink both alarm hour and alarm mode with a beep. Press alarm Mode button 17 to select alarm radio mode until display shows . Press + or ­ to adjust required alarm hour then press SET button again, display minute digits will blink. [. . . ] The Nap timer starts when you release the key. The alarm signal sounds after the period of time which you have set. If you wish to turn off the Nap timer before the time is up, simply adjust the number of minutes by pressing NAP key to OFF and release. When Nap timer signal is on, turn off the timer signal by pressing key 1 Power on/off. [. . . ]