User manual SANGEAN RCR-5

[. . . ] Power sources: The radio should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your radio dealer or power company. Power cords: The power cord should be positioned so it is not walked on, pinched, or items placed on top of it. Pay particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit. [. . . ] After the time is under setting, the setting won't be cancelled even you don't press any button for more than 30 seconds. You need to press the TIME SET button to complete the setting, and the second digit will be set to 0 at the moment when you press the TIME SET button. Turn on the radio with the POWER button. Press the TUNING up/down button, to tune into the frequency of your desired stations 2. scanning tuning- Press and hold the TUNING up/down button for more than 0. 5 seconds and release, the radio will search for the next station. Tune into the stations that you would like to store. Select a STATION PRESET button (1-5) and press it for more than 2 seconds until a beep sounds and the station is now stored. Note: When you store a new station in a preset, the station previously stored will be automatically erased. Alarm setting can be done while the power is during ON or OFF position. The alarm clock is equipped with two alarm systems which can be operated independently of each other. Before the display goes back to the clock, press TIME SET button for 2 second until you hear the beep. Press the TIME SET button and then press the TUNING up/down button to select if the alarm should work on daily, weekday (Monday to Friday), weekend (Saturday and Sunday), or only once. If the RADIO ALARM is selected ­ press the TIME SET button and then select the radio band and the frequency to choose the alarm radio station. Then press the TIME SET button to complete the setting. The setting will automatically complete the setting after 30 seconds without any button pressed. But when the ALARM RADIO is under setting, it will not complete automatically until the TIME SET of POWER button is pressed. After the alarm is set, the alarm status will be shown for 6 seconds then will go back to the clock. * HWS(Human Wake System): In buzzer alarm mode, the buzzer sound will increase in volume for 1 minute, then followed by 1 minute silence, then repeat the cycle for 1 hour. Deactivate alarm setting Press the ALARM 1 or ALARM 2 button for 2 seconds until you hear the beep. To reactivate the alarm, press the ALARM 1 or ALARM 2 button for 2 seconds until you hear the beep. The alarm stops and begins again with interval of 5 minutes. [. . . ] If this radio was bought in Europe, the FM tuning step selections are 50KHz/step and 100KHz/step. : If you don't wish to make any change, don't press the TUNING up/down button. 10kHz/step should be selected when you are in Europe. 9kHz/step should be selected when you are in USA. [. . . ]