User manual SANGEAN U1

[. . . ] A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet. [. . . ] The high impact cushion around the radio is made to endure a six-feet drop and also water resistant housing provides protection when used poolside, by the lake and outdoors. the U-1 has been fully tested to be certain it meets Sangean quality control standards. Please read this manual carefully before using it to make sure you realize all the outstanding features built into this terrific radio set. Power and AM/FM/AUX IN band selector Tuning LED indicator 3 Tuning Control 5 Battery Compartment Volume Control 7 LED illuminator switch AUX/FM band indicator DC IN (9-14V) socket for vehicle and boat power 10 Microphone socket LED light 12 Headphones socket AUX IN socket 14 Loudspeaker Open to AC cord compartment 16 Carrying Handle AM band /Microphone indicator Soft and bendable spring antenna 18 Dial scale Battery operation Installing the batteries, first turn battery cover fixture anti-clockwise to loosen and put down the battery cover. Insert 6 x D size ( UM-1 ) battery into the compartment. ensure the battery is inserted in accordance with the diagram shown. Close the battery cover and fasten the fixture by turning clockwise. If the radio is not to be used for any extended period of time, it is recommended that the battery is removed from the radio. AC operation Before you plug the AC cord into the AC socket, be sure the voltage is correct. If you have batteries in the radio and use the AC power cord , the batteries will automatically be disconnected. Switch the "Open" to the AC cord compartment to OPEN position, pull back the compartment door and cylinder of the AC cord storage, pull out the AC cord to get the required length to the AC socket. You can store the AC cord after use in the opposite way you pull out the AC cord. Powered via DC IN socket The radio can be also powered via the DC IN socket which can allow 9-14 Volt DC. Which is designed to be powered by the vehicle or the boat so you can take the radio with you outdoors or on the boat. [. . . ] You can press and release the LED illuminator switch to give signal. if press harder and release , the LED illuminator is lit on for illumination purpose. Press the switch harder again to turn off the LED illuminator. [. . . ]