User manual SANUS FLAT PANEL FOUNDATIONS TV STAND-PFFP

[. . . ] Proceed to insert two M6 x 20 Bolts (p) into the holes on the back of the Pillar as seen in Diagram 1b. Tighten the M6 x 20 Bolts with a Phillips screw driver. Thread an M8 Allen Bolt (q) through a Spring Washer (r), an M8 Washer (s), the Shelf Bracket (g), and into the Shelf Plate (e). See Diagram 2 for the proper assembly of these parts. [. . . ] Take the Glass Shelf Washer (h) and insert it onto the Glass Shelf (b). make sure the holes in the Glass Shelf Washer and the Glass Shelf match up. Then, proceed to slide the Glass Shelf and the Glass Shelf Washer into the Shelf Bracket (g). Thread each 1/4-20 Allen Bolt (t) down through a Plastic Washer (u), the Glass Shelf, the Glass Shelf Washer, and into the Shelf Bracket. Next, add the Top Cap (j) to the top of the Pillar (d) by lining up the two plastic dowels on the bottom of the Top Cap with the corresponding pattern on the top of the Pillar as seen in Detailed View B of Diagram 6b. Press down firmly on the Top Cap to make sure it is in place. Step 7: Always make sure the television is unplugged before threading any bolt into the back panel!Thread bolts carefully into your television by hand before tightening. if you feel resistance , remove the bolt immediately!If you are unable to find appropriate hardware for your television, consult a local hardware store or call Sanus Systems. Locate the threaded inserts on the back of your flat panel television and determine which of the provided Bolts (v, w, x, y, z, aa, bb, cc) is the correct diameter. To test each diameter, thread the Bolts carefully into your television by hand until you find the diameter that correctly fits. Next, determine the correct length of the required Bolt. If the back of your TV is flat, use one of the shorter Bolts without a Spacer. The back of some flat panel televisions are curved or have recessed threaded inserts. This may require you to use one of the longer Bolts, and a Spacer (ii, jj) between the television and the Monitor Bracket (k, l). Once you have the correct bolt selected, you can follow the diagrams below to see what additional hardware you will need to mount the Monitor Brackets to your TV. every Bolt will require a Lock Washer (ee , ff , gg , hh). You will use four of each part every time it is listed below to attach the Monitor Brackets to your TV. For a TV with a flat back, see Step 8 for installation instructions. [. . . ] The Monitor Brackets should be vertically as close to the center of the TV as possible. Lightly tighten knobs on the Monitor Brackets once they are properly connected to the TV. Step 11: Lifting the television may require two people!To hang the TV onto the Wall Bracket (c) first hook the Monitor Brackets (k, l) over the top of the Wall Bracket, then let the bottom of the Monitor Brackets rotate in under the bottom of the Wall Bracket as shown in the Detailed View of Diagram 11. [. . . ]