User manual SANUS VISIONMOUNT SIDE SPEAKER MOUNT-XAS1A

[. . . ] XAS1A (6901-100148 <01>) Thank you for choosing the Sanus Systems XAS1A. The XAS1A is designed to mount speakers on each side of a VMDD26 VisionMount full motion TV mount. The XAS1A will support speakers weighing up to 11 kg (25 lbs. ) each. CauTION Do not use this product for any purpose not explicitly specified by Sanus Systems. [. . . ] Remove the safety bolt [a] as shown. [a] Lift the TV and arm assembly [B] off the wall plate [C] as shown Lean the assembly against a wall or other vertical surface. [B] HEAVY!You will need assistance with this step. [C] [D] [F] Using an Allen Key, loosen the eight vise assemblies [D]. Remove the lower cross tube [E]; then, remove the upper cross tube [F] as shown. [E] [D] 6901-100148 <01> 2: Cross Tube Installation [25] [02] [J] [G] [02] [H] Slide the cross tubes [02] into the first monitor bracket [g], through the arm assembly [H] and then through the second monitor bracket [J]. Center the cross tubes on the back of the TV. Using the Allen Key, tighten the six vise assemblies until the cross tubes no longer rotate. Attach the TV and arm assembly to the wall plate according to the instructions provided with the VMDD26 Full Motion Mount. You will need assistance with this step. NOTE If you no longer have your VMDD26 Installation Manual, download one from www. Sanus. com or call Sanus Systems Customer Service. 3: Install Extension Tubes [02] Slide the four extension tubes [03] (felt end first) into the cross tubes [02]. [03] [03] [03] [03] [02] 6901-100148 <01> 4: Install Threaded Tube Clamp & Clamp Knob Slide the threaded tube clamps [05] onto the extension tubes [03], aligning the notches in the threaded tube clamp and cross tubes [02]. Snap the threaded tube clamps onto the cross tubes. Thread a clamp knob [04] onto each threaded tube clamp [05]. [02] [06] [05] [03] [02] [03] [05] [06] 5: Secure Vise assemblies to Brackets [04] [07] [22] [01] 4x NOTE Do not overtighten the nut [22]. The vise assembly [04] must rotate freely around the carriage bolt [07]. 6901-100148 <01> 6: attach Speaker Brackets [25] Slide the speaker brackets [01] into the extension tubes [03]. Use the Allen key to tighten the four vise assemblies [04] until the speaker brackets do not slide on the extension tubes. NOTE Maximum extension of the cross tubes is 162 cm (64 in. ). Do not exceed the maximum extension. [03] [01] [04] [03] 6901-100148 <01> 7: attach Speakers 7 - 1: attach Speakers using Threaded Fasteners [03] [03] [08] - [13] Determine the thread of the fastener required by threading each size fastener into the back of the speaker. Stop immediately if you encounter any resistance. [. . . ] The information contained in this document is subject to change without notice or obligation of any kind. CSAV makes no representation of warranty, expressed or implied, regarding the information contained herein. CSAV assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. 6901-100148 <01> [. . . ]