User manual SANUS WOODBROOK FURNITURE VIDEO STAND-WFV44

[. . . ] Check carefully to make sure that there are no missing or defective parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replacement parts for products purchased through authorized dealers will be shipped directly to you. Improper installation may cause damage or serious injury. [. . . ] Detailed View Diagram 3 d u hinge holes a b p Step 4: Add Center Panel Press fit the Center Panel (w) against the Stretchers (o, p) so the Cam Pin (a) goes into the hole which the Cams (b) point to. Tighten each Cam in a clockwise motion until the Stretchers are secured to the Center Panel. Note: Make sure the hinge holes on the Center Panel are on the same side as the Front Stretchers. Detailed View Diagram 4 o a w hinge holes d Step 5: Add Stretchers Add the Front and Back Stretchers (o, p) to the Center Panel (w), by aligning the Cam Pin (a) with the hole which the Cams (b) point to. The Dowel (d) goes into the adjacent hole. Make sure the stretchers are oriented so the Cams face inward. Tighten each Cam closest to the Center Panel in a clockwise motion until the stretchers are secured. Note: Front stretchers attach to the same side as the hinge holes are on. Diagram 5 Detailed View x a b hinge holes d p Step 6: Add Side Panel Press fit the Side Panel (v) against the Stretchers (o, p) so the Cam Pin (a) goes into the hole which the Cams (b) point to. The Dowel (d) going into the adjacent hole. Tighten each Cam in a clockwise motion until the Stretchers are secured to the Side Panel. Note: Make sure the hinge holes on the Side Panel are on the same side as the Front Stretchers. Detailed View Diagram 6 a hinge holes o v Step 7: Add Shelf Pins and Bottom Shelf Thread the Shelf Pins (e) into the bottom hole in the line of holes in each Panel (u, v, w). Tighten Shelf Pins with a Phillips screw driver. Add the Bottom Shelf (q) by inserting it into the assembly and press fit it onto the Shelf Pins. Make sure the Bottom Shelf is flush against the Front Stretcher (o). If there is a gap in front, shelf may be backward. Detailed View Diagram 7 u w e q v Step 8: Add Top Gently tap a Dowel Pin (c) into the holes on the top of each Panel (u, v, w). Press fit the Top (n) so it fits onto the Dowel Pins. Detailed View Diagram 8 n c g v Step 9: Prepare Doors Insert each Phillips Bolt (h) through the Door (s) and into the Door Handle (i). [. . . ] Repeat process until each Back Panel is secured with four Wood Screws. Tighten each with a Phillips screw driver. Detailed View Diagram 11 f x p Step 12: Hinge Adjustment for Woodbrook Door Each hinge Assembly is adjustable in multiple directions. Diagram 12 Side Adjustment Depth Adjustment Height Adjustment Sanus Systems 2221 Hwy 36 West, St. [. . . ]