User manual SANWA MX-3S

[. . . ] The following diagram shows a typical connection for the servos and receiver. Note that the receiver antenna should be located at least 2" (50mm) away from any servo leads and switches. In electric cars, we recommend that it be at least 4" (100mm) from the electric motor. Extend the receiver antenna to the full length. [. . . ] Failure to do so will cause loss of control. Do not cut or bend the receiver antenna. Insulate the connectors with tape or use tie wraps to avoid contact with metal car chassis. Please follow the model manufactures recommendations for the correct installation of your radio system in your car or boat. TROUBLESHOOTING GUIDE and WARNINGS If your radio system does not operate properly, please check the following items: 1. Make sure the batteries are properly installed and fully charged. With alkaline batteries, make certain the batteries are installed in the correct direction. Check that both the transmitter and receiver power switches are in the ON position. Check the battery voltage by turning on the transmitter and pushing both menu bottons at the same time and releasing. Make sure that the proper frequency crystals are installed in both the transmitter and receiver. Make sure all the receiver and servo connections are tight. The screen will now display the model number you are currently using. To change models, press the (INC or DEC) key to select model 1 ~ 5. Range 1 ~ 5 Power Switch Default Channel 3 (AUX) H TH D/R EPA ARC MODEL SUB-T REV Arc MODEL ST TH L L BATT 05 R ST Press the left menu key to move the cursor to ARC. Adjust the ARC by pressing the (INC or DEC) key. Press the left menu key to adjust the ST. (NOTE) Steering ARC will work in both left and right directions. Throttle ARC only works in forward direction. ST TH 0 0 H TH D/R EPA ARC MODEL SUB-T REV BATT Crystal MODEL Range - 100 ~ 100 Default 100% ST 100% TH 100% AUX 0% ~ 120% 0% ~ 160% 0% ~ 140% 0% ~ 150% H TH D/R EPA ARC MODEL SUB-T REV End Point Adjustment MODEL Menu Keys L L R L L 100 5 % L R ST TH AUX BATT ST Press the left menu key to move the cursor to EPA. The screen will now display AUX (L) or (R). Buy moving the AUX channel lever, you will see the (L or R) change. EPA can be set for ST: Range both directions. To set TH, move trigger forward or back TH-L: Range TH-H: Range to see (H or L). [. . . ] EPA can be set for ST: Range both directions. To set TH, move trigger forward or back TH-L: Range TH-H: Range to see (H or L). Move steering wheel to see (L or R) AUX: Range ST MENU Wrist Strap Support MX-3SS - + INC / DEC SYSTEM SPECIFICATIONS Transmitter Model: Output power: Modulation: Power supply: Weight: Frequencies: MX-3SS 200 MW FM/PPM 8 AA alkaline dry cells DC 12V or 8 cell NiCd Pack. 14. 46 ounces 27 MHz (6) frequencies 75 Mhz (30) frequencies Servo Model: Power supply: Dimensions: Weight: Speed: Torque: Accessories 97001Z switch harness Frequency flag Receiver dry battery holder instruction manual Options 94102Z Heavy duty standard servo DC 4. 8 ~ 6. 0V 1. 54"(L) x 0. 79"(W) x 1. 42"(H) 1. 59 ounces 0. 16 sec. [. . . ]