User manual SANYO CE42LH2R

[. . . ] INSTRUCTION MANUAL CE42LH2R CE42LH2DPB CE42LH2WP LCD Monitor Please read this Instruction book before using your LCD monitor. We wish you many hours of pleasure from your new LCD monitor. GB TABLE OF CONTENTS GB TABLE OF CONTENTS . 4 Federal Communications Commission Notice . 16 PC/DVI-D/COMPONENT SIGNAL SUPPORT TIMING LIST . [. . . ] Press the or button on the remote control to select either Auto, Standard or Off. DNR (Digital Noise Reduction) is available for noise reduction. Press the or button on the remote control to select either Auto, Low, Mid, High or Off. MPEG NR (MPEG Noise Reduction): Removes unwanted ringing and pression and decompression. Press the or button on the remote control to select On or Off. Film Mode on material which underwent technologic conversion to video. Press the or button on the remote control to select On or Off. Weekday from Sunday through to Saturday or Everyday using the button. or Time Use to set the schedule for "Power On" or "Power Off" of any time using the Numeric buttons. Action Use to set the schedule for "Power On" or "Power Off" active using the or button. You can set Power On timer in Time menu selecting "ON" in "On Timer Function" in Installation Mode. If it is selected "OFF", Power On display in Time menu does not functional. On Program Use to select AV1, RGB, AV2, AV3, PC, DVI or Network for the schedule of "Power On" using the or button. Active Use to select ON or OFF using the or button. When set Program" will be inactive. Use NUMERIC buttons [0 ~ 9] to set On Time. (Action "Power On" ­ 00:00 ~ 23:59) Once On Time has been set, when the set time is reached, the monitor will leave the stand-by status and enter to the source automatically. After On Time has been set, you can go on watching other programs. When the set time is reached, the monitor will automatically switch to the preset program. On Program can only be selected whenAction (Power On) has been set. Action (Power Off) can be set to turn the monitor into standby at a selected time Once On Program has been set, when the set time is reached, the monitor will enter to the preset source automatically. Use the or button to select On program, AV1, RGB, AV2, AV3, PC, DVI or Network. Sound menu Press the MENU button and select Sound using the tons, press the or button to enter. or but- Select and adjust to obtain the best sound settings for your environment using the or button to select Treble, Bass or Balance and the or button to adjust levels. Bass Expander can also be selected using the or button and pressing the or button to select On or Off. These settings automatically store when you exit the menu. Press the BACK button to return to the previous menu. [. . . ] Status of MPEG NR setting. PC Read Command Table Status read command CR H-POS CR V-POS CR PHASE CR CLOCK Item Status of Horizontal position. Status of CLOCK value. RC inhibition OFF RC inhibition ON Input Read Command Table Status read command CR INPUT CR SOURCE CR SYSTEM Item Status of Input selection. Status of system of Input mode. Screen Read Command Table Status read command CR SCREEN Item Status of screen size. (The same of WIDE mode) 18 GB Time Read Command Table Status read command CR PANELH CR MONH Item Status of accumulated lifetime of panel. [. . . ]