User manual SANYO CLT-9935

[. . . ] CLT-9922NEW 7/2/02 11:09 AM Page 1 INTRODUCTION Congratulations on your purchase of this Sanyo cordless telephone. Your Sanyo 900-MHz cordless telephone is a fine-quality home communications product. It is carefully designed and produced by a world leader of consumer and industrial electronics equipment. With proper maintenance and care, it will provide you with years of enjoyment and convenience. [. . . ] The following example shows how you can chain dial to make a call through a long distance service: The Number for: Long distance access number Authorization code Frequently called long distance number Memory Location 7 8 9 HEADSET JACK AND BELT CLIP (CLT-9935 and CLT-9925 only) For hands free conversation, connect any standard shielded headset with a 2. 5-mm plug (not included) to the HEADSET jack as shown. The handset receiver and microphone are disabled when the headset is connected. · Press TALK/CALLBACK to answer or place a call before using the headset. Belt clip installation · Attach the belt-clip by inserting the clip into the slots on the side of the handset. Snap the ends of the belt clip into place. CHANGING THE BATTERY Battery replacement and handling When the operating time becomes short even after a battery is recharged, please replace the battery. With normal usage, your battery should last about one year. For a replacement battery, please contact your place of purchase or fill out the attached order form and mail it. Note: Repeated short chargings may cause memory effect in the battery, which reduces use time of the battery. It is recommended not to replace the handset to the base unit after each call. Caution · Use only the specified battery type (3. 6V, 600mAh). · Do not remove the battery from the handset to charge it. · Never throw the battery into a fire, disassemble it, or heat it. · Do not remove or damage the battery casing. · Remove battery if storing the phone over 30 days. Make sure the telephone is off before you replace the battery. Slide off the battery compartment cover. Disconnect the battery plug from the jack in the compartment and remove the battery. Insert the new battery and connect the cord into the jack. Put the battery compartment cover back on. Note: If the handset battery is removed for more than 5 minutes, the directory memory and Caller ID memory will be erased. Charge the handset battery for 12 continuous hours prior to first use. Caution: To reduce the risk of fire or personal injury, use a 3. 6V, 600 mAh battery. [. . . ] SANYO CANADA INC. 'S RESPONSIBILITY During the warranty period, SANYO Canada Inc. will repair, or at our option, replace a Communications product which shows evidence of a manufacturing defect in materials or workmanship. Replacement PARTS are warranted for the remaining portion of the warranty period. Communications products purchased outside Canada. [. . . ]