User manual SANYO EM-Z2000S

[. . . ] (c) Do not operate the oven if it is damaged. It is particularly important that the oven door close properly and that there is no damage to the: (1) DOOR (bent) (2) HINGES AND LATCHES (broken or loosened) (3) DOOR SEALS AND SEALING SURFACES (d) The oven should not be adjusted or repaired by anyone except properly qualified service personnel. SPECIFICATIONS Model: Power Source: Power Consumption: Microwave Maximum Output: Grill Power Consumption: Oven Capacity: Turntable Diameter: Outside Dimensions: (w x h x d) Weight: Approx. EM-Z2000S AC 120 V, 60 Hz 1350W 900W 1000W 0. 8 cu. 113/16" 20" x 131/4" x 1611/16" 38 lbs. Specifications subject to change without notice. [. . . ] Unplug the oven from the wall outlet and then plug it back in. The microcomputer will then reset for proper functioning. Why is there noise coming from the turntable when the oven is turned on?This noise occurs when the turntable roller rest and cavity bottom are dirty. Clean the turntable roller rest cavity bottom. Frequent cleaning of these parts should eliminate or reduce the noise. Why is there noise coming from the oven when reducing power?When cooking with a power other than maximum (100%), the oven cycles to obtain the lower power level. The clicking noise can be heard when the oven cycles on and off. Why is there steam coming out of the air exhaust vent?The microwave oven has been made to vent this steam. Never use cleaning powders or rough pads. After cleaning the control panel, press STOP/CANCEL to clear any entries that might have been entered accidentally while cleaning the panel. MAINTENANCE 23 25941_EM_Z2100GS manual. qxd 7/7/05 8:32 AM Page 24 SANYO MICROWAVE OVEN LIMITED WARRANTY OBLIGATIONS MODEL EM-Z2000S In order to obtain warranty service, the product must be delivered to and picked up from an Authorized Sanyo Factory Service Center at the user's expense, unless specifically stated otherwise in this warranty. The names and addresses of Authorized Sanyo Service Centers may be obtained by calling the toll-free number listed below. For product operation, authorized service center referral, service assistance or problem resolution, call CUSTOMER INFORMATION 1- 800 - 421- 5013 Weekdays 8:00 AM - 5:00 PM Pacific Time For accessories and/or parts not available from an authorized dealer, call PARTS ORDER INFORMATION 1 - 800 - 726 - 9662 Weekdays 8:00 AM - 5:00 PM Pacific Time THIS WARRANTY IS VALID ONLY ON SANYO PRODUCTS PURCHASED OR RENTED AND USED IN THE UNITED STATES OF AMERICA, EXCLUDING ALL U. S. THIS WARRANTY APPLIES ONLY TO THE ORIGINAL RETAIL USER, AND DOES NOT APPLY TO PRODUCTS USED FOR ANY INDUSTRIAL, PROFESSIONAL OR COMMERCIAL PURPOSE. THE ORIGINAL DATED BILL OF SALE, SALES SLIP OR RENTAL AGREEMENT MUST BE SUBMITTED TO THE AUTHORIZED SANYO SERVICE CENTER AT THE TIME WARRANTY SERVICE IS REQUESTED. Subject to the OBLIGATIONS above and EXCLUSIONS below, SANYO FISHER COMPANY (SFC) warrants this SANYO product against defects in materials and workmanship for the periods of LABOR and PARTS specified below. SFC will repair or replace (at its option) the product and any of its parts which fail to conform to this warranty. The warranty period commences on the date the product was first purchased at retail. LABOR 1 YEAR PARTS 1 YEAR EXCLUSIONS This warranty does not cover (A) the adjustment of customer-operated controls as explained in the appropriate model's instruction manual, or (B) the repair of any product whose serial number has been altered, defaced or removed. This warranty shall not apply to the temperature probe, turntable, turntable roller, grill rack, shelf, stirrer cover and any damage initiated by spark fires caused by using anything metal inside the oven, except those accessories approved by SFC. This warranty does not apply to uncrating, setup, installation, removal of product for repair, or reinstallation of the product after repair. [. . . ] Sujeto a las OBLIGACIONES de arriba y a las EXCLUSIONES de la página siguiente, SANYO FISHER COMPANY (SFC) garantiza este producto Sanyo contra defectos de materiales y de mano de obra durante los períodos especificaciones para MANO DE OBRA y para PIEZAS siguientes. SFC reparará o reemplazará (según crea conveniente) el producto y cualquiera de sus piezas que no satisfagan esta garantía. El período de garantía comienza en la fecha de la primera adquisición del producto o de alquiler del producto al por menor. MANO DE OBRA 1 AÑO PIEZAS 1 AÑO EXCLUSIONES Esta garantía no cubre (A) el ajuste de los controles operados por el usuario como se explica en el manual de instrucciones del modelo apropiado, ni (B) la reparación de ningún producto cuyo número de serie haya sido alterado, deformado o extraído. Esta garantía no se aplicará a la sonda de temperatura, bandeja rotativa, rodillo de la bandeja rotativa, parrilla doradora, estante, cubierta agitadora, y cualquier daño iniciado por chispas de fuego causadas por cualquier metal en el interior del horno, excepto los accesorios aprobados por SFC. [. . . ]