User manual SANYO HPS-SG3

[. . . ] If your projector seems to operate improperly, read this manual again, check operations and cable connections and try the solutions in the "Trouble-shooting" section of the end of this booklet. If the problem still persists, contact the sales dealer where you purchased the projector or the service center. SAFETY PRECAUTIONS WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. q This projector produces intense light from the projection lens. Do not stare directly into the lens as possible. [. . . ] Press POINT DOWN button to move a red arrow pointer to Input 1 and then press SELECT button. Move a pointer to either Digital or Analog and then press SELECT button. When your computer is connected to COMPUTER INPUT (DIGITAL) terminal, select RGB (Digital). When your computer is connected to COMPUTER INPUT (ANALOG) terminal, select RGB (Analog). INPUT MENU INPUT Menu icon Move a pointer (red arrow) to Input 1 and press SELECT button. Input 1 Source Select Menu Move a pointer to Digital or Analog and press SELECT button. Digital Analog WHEN SELECT INPUT 2 (5 BNC INPUT JACKS ) When connect a computer output [5 BNC Type (Green, Blue, Red, Horiz. Sync. )] from a computer to G, B, R, H/HV and V jacks. INPUT MENU INPUT Menu icon 1 2 3 Press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button to move a red frame pointer to INPUT Menu icon. Press POINT DOWN button to move a red arrow pointer to Input 2 and then press SELECT button. Press POINT DOWN button and a red-arrow icon will appear. Move arrow to "RGB", and then press SELECT button. Input 2 Move a pointer (red arrow) to Input 2 and press SELECT button. Source Select Menu Move a pointer to RGB and press SELECT button. 22 COMPUTER INPUT AUTOMATIC MULTI-SCAN SYSTEM This projector automatically tunes to most different types of computers based on VGA, SVGA, XGA or SXGA (refer to "COMPATIBLE COMPUTER SPECIFICATION" on page 26). When image is not provided properly through this function, manual adjustments are required. (Refer to page 24, 25. ) q Auto PC Adjustment function cannot be operated in Digital Signal input on DVI terminal and "RGB", "720p (HDTV)", "1035i (HDTV)" or "1080i (HDTV)" is selected on PC SYSTEM Menu. 23 COMPUTER INPUT MANUAL PC ADJUSTMENT This projector can automatically tune to display signals from most personal computers currently distributed. However, some computers employ special signal formats which are different from standard ones and may not be tuned by Multi-Scan system of this projector. If this happens, projector cannot reproduce a proper image and image may be recognized as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture. This projector has a Manual PC Adjustment to enable you to precisely adjust several parameters to match with those special signal formats. This projector has 5 independent memory areas to memorize those parameters manually adjusted. This enables you to recall setting for a specific computer whenever you use it. Note : This PC ADJUST Menu cannot be operated when in digital signal input on DVI terminal and "RGB" is selected on PC SYSTEM MENU (P23). 1 2 Press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button to move a red frame pointer to PC ADJUST Menu icon. Press POINT DOWN button to move a red frame pointer to item that you want to adjust and then press SELECT button. Press POINT LEFT/RIGHT button to adjust value. [. . . ] Make sure you are not too far from a projector when using Remote Control Unit. Maximum operating range is 16. 4' (5m). q Check transmitted signal mode from Remote Control Unit. (See"SETTING" section on page 36. ) q Check cable connection between a projector and your computer. [. . . ]