User manual SANYO LNS-S02Z LENS REPLACEMENT AND INSTALLATION PROCEDURES

[. . . ] LNS-S02Z LENS REPLACEMENT AND INSTALLATION PROCEDURES NOTES ON REPLACEMENT AND INSTALLATION The procedures and the needed pars for lens installation depend on the type of cabinet. Before installing or replacing the lens, make sure the type of cabinet and be sure to refer to the Installation Manual corresponding with your projector. When installing or replacing the lens, make sure the Lens Model No. [. . . ] Check no wiring is tangled on the gear of lens motor or the other mechanical parts. Check no part is missing, or no mounting part is loose. Some parts are not used for installation or replacement. Note : Figures in this manual may be differ from the actual product. LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps 1 to 5 for lens replacement and installation. UPPER LENS COVER C 1 REMOVE THE LENS COVER. Pull down the lower lens cover while pushing the part D, then remove it. Remove screws C (2 screws) and remove upper lens cover. D D A B Fig-1 LOWER LENS COVER 2 REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-2) Remove 2 screws and pull down the plate. (At the step 4 , insert the light-block sheet in the same position as the removed cover plate has been placed. Two screws are not used. ) COVER PLATE 3 INSTALL THE LENS. Remove protective caps(front and back) on the lens. Mount the lens on mounting bracket of the main cabinet with 4 screws. Use the screws included with the lens. Use the driver included with the lens to fasten the screws. (After using, save it for latter use. ) 3. Connect the lead connector of the lens motor to the "K16B" on the circuit board as shown in figure-4. [. . . ] Insert the upper part lens cover and fix them with screws A (4 screws). Insert the lower part lens cover and fix them with screws B. (2 screws). A B LOWER LENS COVER Fig-6 [. . . ]