User manual SANYO LNS-S03 LENS REPLACEMENT AND INSTALLATION PROCEDURES

[. . . ] Refer to the catalog, or contact your sales dealer for the proper Lens Model No. TYPE OF THE CABINET AND INSTALLATION PROCEDURES Refer to the Installation procedure corresponding to your projector and install the lens correctly. (See the chart below. ) Type of the Cabinet (1) See Page 2 Type of the Cabinet (2) See Page 6 For use the other models (other than above cabinet), contact your sales dealer. 1AA6P1P2987-- (IDAJ) NOTES ON LENS INSTALLATION · Lens installation and replacement should be made by the qualified service personnel. · Be sure to install the lens following this procedure precisely. · The lens cover is on the lens for protection. [. . . ] 4. ) GUIDE PIN LENS MOUNTING BLACKET DRIVER IN THE LENS Part No. (610 275 6029) LOCATE MOTOR ON RIGHT SIDE Fig-4 5 Connect Lens Motor Lead to the connector "K96T" on the circuit board under the lens. K96T CONNECTOR LENS MOTOR LEAD Fig-5 -3- 6 Use a Light-Block Sheet (provided with projector) corresponding with lens. below. ) Set Light-Block Sheet through the lens. Make sure the shape of Light-Block Sheet and be sure to set them as shown in the Fig. NOTE: Be sure to set a Light-Block Sheet as shown in Fig-6. Make sure the mark (TOP and BACK) on Light-Block Sheet and set them properly. 610 290 9258) Fig-6 LIGHT BLOCK SHEET Make sure the sheet figure and put on proper position. -4- 7 8 9 Replace Upper Lens Cover. Slide Light-Block Sheet into the guide of Upper Lens Cover and set them in front of the flap. 7. ) Fix Upper Lens Cover with 4 Screws C. Slide Light-Block Sheet into the guide of Lower Lens Cover and set them in front of the flap. 7. ) Fix Lower Lens Cover with 2 Screws A. 1. ) Turn the projector on and operate Lens shift, Zoom and Focus fully to check Light-Block Sheet. If Light-Block Sheet interfere with those operations, check Light-Block Sheet is set properly. Slide upper both side of LIGHT BLOCK SHEET into between 1 and 2 . FLAP 2 GUIDE 1 UPPER LENS COVER LIGHT-BLOCK SHEET LOWER LENS COVER FLAP Fig-7 -5- LENS REPLACEMENT AND INSTALLATION PROCEDURE {Type (2) Cabinet} A 1 Remove Lens Cover. Push part B and pull Upper Lens Cover up. 1. ) UPPER LENS COVER B Fig-1 C 2 Remove 4 Screws C. Pull Lower Lens Cover toward front and remove. 2. ) LOWER LENS COVER C Fig-2 D 3 Remove 2 Screws D and Cover Plate on the back of Upper Lens Cover. 3. ) UPPER LENS COVER COVER PLATE Fig-3 -6- 4 Replace Lens Cap on the rear (mounting side) of Projection Lens and mount the lens on Lens Mouting Bracket with 4 Screws. [. . . ] 7. ) Fix Lower Lens Cover with 4 Screws C. Slide Light-Block Sheets into the guide of Upper Lens Cover and set them in front of the flap. 7. ) Fix Upper Lens Cover with 2 Screws A. 1. ) Turn the projector on and operate Lens shift, Zoom and Focus fully to check Light-Block Sheets. [. . . ]