User manual SANYO LNS-T03 LENS REPLACEMENT AND INSTALLATION PROCEDURES

[. . . ] Refer to the catalog, or contact your sales dealer for the proper Lens Model No. TYPE OF THE CABINET AND INSTALLATION PROCEDURES Check the type of cabinet of your projector and follow the respective installation procedure to install the lens correctly. Type of the Cabinet (1) (See Page 2) Type of the Cabinet (2) (See Page 5) For lens installation to the other models than above, contact your sales dealer. 1AA6P1P4097-- (IDLS) NOTES ON LENS INSTALLATION · Lens installation and replacement should be made by the qualified service personnel. · Be sure to install the lens following this procedure precisely. · The lens cover is attached to the lens for protection. [. . . ] 3. ) COVER PLATE D Fig-3 -2- 4 Remove Lens Protection Cap from the rear (mounting side) of the Projection Lens and attach the lens Attachment to the lens with 4 Screws. (Use screws attached to the lens. ) See Fig. 4. LENS LOCK LEVER LENS ATTACHMENT Lens Attachment 01 POA-LNA-01 (610 303 8742) DRIVER INCLUDED IN THE LENS PACKAGE Part No. (610 275 6029) Fig-4 LENS MOUNTING BRACKET Fig-5 5 6 Grasp (release lock) the Lens Lock Lever and turn it fully upward. 6) Mount the Lens into the lens mounting bracket and grasp the lens lock lever and turn it counterclockwise until the lever is locked. 5 and 7) After installing the lens, make sure the lens is not loose and properly installed. Set up the projector and project image on the screen. Turn the lens part "A" to adjust ZOOM. Turn the lens part "B" to adjust FOCUS. LENS LOCK RELEASE Grasp (unlock) Lens Lock Lever and pulling upward. Grasp (unlock) Lens Lock Lever and fully pulled downward until it is locked (clicked). LENS LOCK Turn the lens part "A" to adjust ZOOM. A B Turn the lens part "B" to adjust FOCUS. Fig-6 Fig-7 LENS INSTALLATION NEEDS TWO OR MORE PEOPLE. TO INSTALL THE LENS BY A SINGLE PERSON MAY RESULT IN A SERIOUS DAMAGE ON THE LENS OR THE PROJECTOR BY DROPPING OR BUMPING THE PRODUCTS. -3- 7 Put back the Upper Lens Cover to the projector and Fix the Upper Lens Cover with 4 Screws C. 2. ) Put back the Lower Lens Cover to the projector. 1. ) UPPER LENS COVER LOWER LENS COVER Fig-8 -4- LENS REPLACEMENT AND INSTALLATION PROCEDURE {Type (2) Cabinet} A 1 Remove 2 Screws A and Remove Upper Lens Cover. Push part B and pull the Upper Lens Cover up and remove it. 1. ) UPPER LENS COVER B Fig-1 C 2 Remove 4 Screws C. Pull the Lower Lens Cover toward front and remove it. [. . . ] Turn the lens part "A" to adjust ZOOM. Turn the lens part "B" to adjust FOCUS. LENS LOCK RELEASE Grasp (unlock) Lens Lock Lever and fully pulled downward until it is locked (clicked). LENS LOCK Grasp (unlock) Lens Lock Lever and pulling upward. Turn the lens part "A" to adjust ZOOM. A B Fig-6 Turn the lens part "B" to adjust FOCUS. Fig-7 LENS INSTALLATION NEEDS TWO OR MORE PEOPLE. TO INSTALL THE LENS BY A SINGLE PERSON MAY RESULT IN A SERIOUS DAMAGE ON THE LENS OR THE PROJECTOR BY DROPPING OR BUMPING THE PRODUCTS. -6- 7 Put back the Lower Lens Cover to the projector and Fix the Lower Lens Cover with 4 Screws C. [. . . ]