User manual SANYO LNS-W01Z LENS REPLACEMENT AND INSTALLATION PROCEDURES
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SANYO LNS-W01Z. We hope that this SANYO LNS-W01Z user guide will be useful to you.
Lastmanuals help download the user guide SANYO LNS-W01Z.
Manual abstract: user guide SANYO LNS-W01ZLENS REPLACEMENT AND INSTALLATION PROCEDURES
Detailed instructions for use are in the User's Guide.
[. . . ] LNS-W01Z / LNS-T01Z
LENS REPLACEMENT AND INSTALLATION PROCEDURES
NOTES ON REPLACEMENT AND INSTALLATION
The procedures and the needed pars for lens installation depend on the type of cabinet. Before installing or replacing the lens, make sure the type of cabinet and be sure to refer to the Installation Manual corresponding with your projector. When installing or replacing the lens, make sure the Lens Model No. [. . . ] Check no wiring is tangled on the gear of lens motor or the other mechanical parts. Check no part is missing, or no mounting part is loose.
Some parts are not used for installation or replacement. Note : Figures in this manual may be differ from the actual product.
LENS REPLACEMENT AND INSTALLATION PROCEDURE
Perform the steps 1 to 5 for lens replacement and installation.
UPPER LENS COVER
C
1
REMOVE THE LENS COVER. Pull down the lower lens cover while pushing the part D, then remove it. Remove screws C (2 screws) and remove upper lens cover. D B
2
IN CASE OF MODEL WITHOUT LENS A
D
Fig-1
LOWER LENS COVER
REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-2) Remove 2 screws and pull down the plate. (At the step 4 , insert the light-block sheet in the same position as the removed cover plate has been placed. Two screws are not used. )
Set the light-block sheet, so that the large rounder side is set over the lens.
SCREWS COVER PLATE
Fig-2
IN CASE OF MODEL WITH LENS REMOVE THE LENS. Remove the connector "K16B" of the circuit board. Loosen the A, B wire holder and remove the lens motor lead. Remove screws D (4 screws) which fastens the lens and remove the lens.
Figure shown inside of the cabinet. (D) (D)
LENS MOTOR
A
(D)
(D)
B A LENS MOTOR LEAD CONNECTOR " K16B"
Fig-3
3
INSTALL THE LENS. (See figure-4)
LENS MOUNTING BRACKET
1. Remove protective caps(front and back) on the lens. Mount the lens on mounting bracket of the main cabinet with 4 screws. [. . . ] Insert the upper part lens cover and fix them with screws A (4 screws). Insert the lower part lens cover and fix them with screws B. (2 screws).
A
B
LOWER LENS COVER
Fig-6 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SANYO LNS-W01Z
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SANYO LNS-W01Z will begin.
