User manual SANYO LNS-W05 LENS INSTALLATION AND REPLACEMENT PROCEDURES

[. . . ] Refer to the catalog, or contact your sales dealer for the proper Lens Model No. TYPE OF THE CABINET AND INSTALLATION PROCEDURES This manual provides the following cabinet type models. For lens installation to the other models than below, contact your sales dealer. Printed in Japan 1AA6P1P4885-- (IDZC) NOTES ON LENS INSTALLATION · Lens installation and replacement should be made by the qualified service personnel. · Be sure to install the lens following this procedure precisely. [. . . ] Make sure the lens is fixed on the projector by lens lock lever. Make sure no part is missing, or loose. Not all the parts included may be used for lens installation or replacement. Note : Illustrations in this manual may differ from the actual product. -1- LENS REPLACEMENT AND INSTALLATION PROCEDURE A 1 Disconnect the power cord from AC outlet. Remove 5 screws (A) from the front cabinet. Pulling up the front cover and remove it. (See Fig-1. ) A A Front Cover Fig-1 2 Pulling up Light Block Sheet Holder and Cover Plate, remove them. (See Fig-2) Light Block Sheet Holder Cover Plate Fig-2 3 Remove the cover plate from the light block sheet holder . (See Fig-3) Cover Plate Fig-3 -2- 4 Remove lens cap on the rear (mounting side) of the projection lens and mount Lens Attachment to the lens with four screws included with the lens. Insert the connector at the end of Lens Motor Lead into the socket located at right-top of the lens attachment. (With motor model only. ) Note : Lens attachment is not included in this lens. Lens Attachment POA-LNA-04 (610 317 1289) Lens Attachment Socket Connector Locate motor on right side. (610 275 6029) Lens Motor Lead Fig-4 Lens Attachment Driver included with the lens Part No. (610 275 6029) Note : Lens Illustrations in this manual may differ from the actual product. 5 Pinch Lens Lock Lever and turn it clockwise to unlock. (See Fig-5. ) Insert the Lens through the lens mounting bracket and turn the lens lock lever anticlockwise until the lens is securely mounted. After installing the lens, make sure the Lens is not loose and properly mounted. (See Fig-6 and Fig-7 on next page. ) Lens Lock Lever Fig-5 -3- Pinch the tab and turn the lever clockwise to unlock the lens. Fig-6 Pinch the tab and turn the lever anticlockwise to lock the lens. Fig-7 CAUTION: Turn the Lens Lock Lever anticlockwise until the lens is locked. Make sure the lens is securely installed after installation. FOCUS ADJUSTMENT (For Model LNS-W07) Set up the projector and project image on the screen. [. . . ] (See Fig-8 and Fig-9. ) Appropriate light block sheet varies depending on the Lens Model No. on the light block sheet and Lens Model No. and use an appropriate one. Note: Make sure the light block sheet is fully inserted into the light block sheet holder when installing the light block sheet and the sheet holder into the projector. [. . . ]