User manual SANYO MAR-B3089

[. . . ] · This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 1 DIN FRONT-MOUNT (METHOD A) Installation with the rubber bushing 1 2 182 1. Half Sleeve After inserting the sleeve into the dashboard, select the appropriate tabs according to the thickness of the dashboard material, then bend them outward to secure the sleeve in place. Screw 53 3 Installation without the rubber bushing 1 4 1. [. . . ] Precautions when Handling the Front Panel 1. Do not put pressure on the display or control buttons when detaching or reinstalling the front panel. Do not touch the contacts on the front panel or on the main unit body. It may result in poor electrical contact. If any dirt or foreign substances have adhered to the contacts, they can be removed with a clean, dry cloth. Do not expose the front panel to high temperatures or direct sunlight. Do not expose the front panel to benzene, thinner, insecticides or any other strong chemicals. These will damage the finish of the panel. Do not attempt to disassemble the front panel. 7 OPERATION CONTROLS AND FUNCTION KEYS 1 14 16 17 15 3 4 2 12 11 7 8 13 18 5 6 10 9 19 1. PWR (=POWER) Press the button to turn on the unit, press again to turn it off. REL (=RELEASE) Press the button to detach the faceplate. SEL (=SELECT) Press to select audio control mode. The desired mode can be selected as below: Volume Bass Treble Balance Fader Each mode is indicated on display. VOL (=VOLUME UP/DOWN) Used for audio UP/DOWN control when the SEL button is pressed. Sound quality is controlled as below: · In volume mode: Press ` ' to increase volume level, and press ` ' to decrease the level. The volume level is updated correspondingly and its status is shown on the display. Note: The unit is initially set to volume mode. · In bass mode: While "BAS" is shown on display, press ` ' to increase bass level, and press ` ' to decrease the level. The bass level is updated correspondingly and its status is shown on display. 8 · In treble mode: While "TRE" is shown on display, press ` ' to increase treble level, and press ` ' to decrease the level. The treble level is updated correspondingly and its status is shown on display. · In balance mode: While "BAL" is shown on display, press ` ' to shift sound level to right speaker, press ` ' to shift sound level to left speaker. The shift point is updated correspondingly and its status is shown on the display. [. . . ] This warranty does not apply to repairs or replacements necessitated by any cause beyond the control of SFC including, but not limited to, any malfunction, defect or failure caused by or resulting from unauthorized service or parts, improper maintenance, operation contrary to furnished instructions, shipping or transit accidents, modification or repair by the user, abuse, misuse, neglect, accident, incorrect power line voltage, fire, flood or other Acts of God, or normal wear and tear. The foregoing is in lieu of all other express warranties and SFC does not assume or authorize any party to assume for it any other obligation or liability. THE DURATION OF ANY WARRANTIES WHICH MAY BE IMPLIED BY LAW (INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS) IS LIMITED TO THE TERM OF THIS WARRANTY IN NO EVENT SHALL SFC BE LIABLE FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM OWNERSHIP OR USE OF THIS PRODUCT, OR FOR ANY DELAY IN THE PERFORMANCE OF ITS OBLIGATIONS UNDER THIS WARRANTY DUE TO CAUSES BEYOND ITS CONTROL. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS AND/OR DO NOT ALLOW THE EXCLUSION OR LIMITATION OF CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO YOU. [. . . ]