User manual SANYO MCD-ZX540F

[. . . ] Doing so may produce an excessively large output from the amplifier which could damage your speakers. Sudden change in the ambient temperature may cause condensation to form on the optical lens inside the unit. If this happens, take out the disc, leave the unit for about 1 hour, and then proceed to operate. Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. - - To be completely disconnect the power input, the mains plug of apparatus shall be disconnected from the mains. [. . . ] - Do not apply paper or write anything on the disc surface. Do not touch the playing surface (glossy side). - Fingerprints and dust should be carefully wiped off the playing surface of the disc with a soft cloth. Wipe in a straight motion from the center to the outside of the disc. - Never use chemicals such as record cleaning sprays, antistatic sprays or fluids, benzene or thinner to clean compact discs. 1. "--" blinks for several seconds then the CD mode appears. Press the CD compartment lid (OPEN/ CLOSE portion) to open it. Place the disc with the label facing up on the turntable as shown below. Press the CD compartment lid (OPEN/ CLOSE portion) to close it. The total number of tracks on the disc appears on the display. Press the PLAY/PAUSE i button. Temporarily stopping play Press the PLAY/PAUSE i button, "a" blinks on the display. To resume play, press the button again. Skip play The current track number appears. - To start play from the desired track, select the track by using the f or e button, then press the PLAY/PAUSE i button. Note: If no disc is loaded or the disc is located with the label facing down "00" appears. If these occur, load the disc correctly or replace the damaged disc. Press the STOP n button to end disc play back. When the last track has been played, the player stops automatically. To turn the CD player off, set the FUNCTION switch to TAPE/OFF . To skip to track 6 while track 3 is playing, press the e button repeatedly until "6" appears on the display. To skip back to track 3 while track 6 is playing, press the f button repeatedly until "3" appears. Search (forward/reverse) If the e or f button is pressed during play, the player will search at high speed in the forward or reverse direction while the button is being pressed. When the button is released, normal play will continue. -4- 540AU. indd 4 2009. 4. 8 10:11:15 AM Repeat playing mode Press the REPEAT button repeatedly to select a repeat play mode available. Each time the button is pressed, the mode changes as shown below: [CD] "REPEAT" blinks (Repeat one track) "REPEAT" appears (Repeat all tracks) 5. Repeat steps 3 - 4 to programme additional tracks. [. . . ] - If the signal from an FM stereo station is weak and reception is poor, set the FM MODE select switch to MONO. The reception may be improved, but the sound will be monaural. To improve reception FM: Pull out the telescopic aerial and adjust its position. AM: Rotate the unit. RECORDING Recording copyright material without permission of the copyright owners is usually an infringement. [. . . ]