User manual SANYO MDF-C8V1 BROCHURE

[. . . ] approximately one half compared to conventional systems. Use of V. I. P ® PLUSTM insulation material on . the front, left, and right sides enables a smaller installation space with exceptional storage capacity to foot print ratio. · Newly developed single-compressor system and enables low-noise operation. [. . . ] conventional systems. to conventionalxxD xlow-noise operation. x27. 0" low-noise xx685 xx945 mm) comparison (115V, 60Hz/230V, 50Hz) *SANYO comparison (115V, 60 21. 6" 27 . 0" 37 . 2" (550 685 945 Exterior dimension (W D x H) *SANYO compared Small ables compared to MDF-C8V eatures Specifications door Outer door/Inner door Outer Lid: 1piece, Inner Lid:Outer Lid: 1piece, Inner *Appearance and specifications are subject to change without notice. *Appearance and specifications are subject to change without notice. SCR-072-I MDF-UBK Compressor Rotary type Outer door/Inner 1piece *Cooling performance is indicated by the temperature reached at the center of the freezer (at ambient temperature of 30°C with no load). PLUSTM insulation material onCperformance is indicated by the temperature reached at the center of the freezer (at ambient temperature of 30°C with no load). MDF-C8V polyurethane foam (HC) SCR-053-I Refrigerant apac HFC p C apac Ca Insulation Cap Insulation ac New VIP® PlusTM Rigid polyure New VIP® PlusTM Rigid comparison O comparison it it the front, left, and rightysides enables a acity ity Temperature range y Evaporator Tube on sheet type -60°C to60 Hz /(1°C increments) / 60 Hz / 1Phase NEM -80°C 1Phase NEMA 5-15P Plug Cooling system Cooling system 115V 115V / ion tion Alarm System 4. 05 sq. ft alarm (±5°C to ±20°C) 5. 65 sq. ft smaller installation space with the highest- High/Low temp. cooling performanceCompressor 5. 65 sq. ft 4. 05 sq. ft -80°C (Ambient temp. 30°C) (1/2 HP) Compressor Rotary type, Output: 400W Rotary type, Output: 400 PerformanceMaximum failure alarm PerformanceData Data Power class storage capacity ratio. 21. 6" x operation 37 (550 x 685 . 0" . 2" Exterior dimension (W x D x H) RefrigerantCO2 backup system27 xcharacteristics HFC x 945 mm) HFC Pull-down characteristics Pull-up characteristics during power failure Pull-down characteristics Refrigerant Pull-up characteristics during power failure CO2 backup system operation characteristics Inner dimension Inner dimension 15. 9" 19. 3" x 16. 9" (405 x 490 x 430 mm) onventional insulation* MDF-C8Vfreezers such as MDF-C8V takes full advan- 15. 9" xx 19. 3" x 16. 9" (405 x 490 x 430 mm) freezers such as MDF-C8V Conventionalinsulation* MDF-C8V takes full advanModel MDF-C8V1 Effective capacity 3. 0cu. ft. (84 Liter) tage ofNet weight -60°C to -80°C (-1°C increments) this feature. capacity Model Use of V. I. P. Cooling Performance material on Maximum PLUS insulation StoragePLUS insulation material on2" box: 42pcs. (SCR-072 MDF-C8V Storage Model 2" More advanced insulation system: capacity-80°C (Ambient temp. (SCR-072 xx66racks) 3" Box: 30 pcs. MDF-C8V Newly developed single-compressor racks) 3" Box: 30 pcs. Outer door/Inner door 21. 6" right Temperature a x Outer Lid: 1piece, Inner the theExterior left, and rightxsidesfront, left, and x 27. 0"sides enablesrange945mm)Temperature Inner Lid: 1piece front, Dimension (W D x H)enables door/Innerdoor 37. 2" (550 x 685 x Outer a Rated increments) to -80°C Outer Lid: -60°C -60°C V. I. P. aapInner DimensionC(W x D x H) PLUSTM system (405 x 490 x 430mm) PlusTM 1piece, rangeLid: 1piece (HC)to -80°C (1°Cpower consumption (1°C inc CCpa Capa Insulation 15. 9" x 16. 9" New VIP® cc aity installation smaller installationapaitity smaller Insulation xspace with the highest-performance Rigid polyurethane foam-80°C (Ambient temp. 30°C)-80°C (Ambient temp space with the highest- 19. 3" Maximum cooling New VIP® PlusTM Rigid polyurethane foam (HC) c Maximum cooling performance 340W/345W SANYO's ity more Capacity c y system system 3. 0a newly developed single-compres- NEMA MDF-C8V Use of cu. ft. (84 liters) Cooling 115V / / 60 Hz / 1Phase NEMA 5-15P Plug 5-15P Plug Cooling Effective advanced insulation storage system 115V 60 Hz / 1Phase class Compressor capacity ratio. 21. 6" 945. 0" x . 2" 21. 6" x 27 . 0" . 2" Exterior dimension (W xRotary type, Output: 400WConventionalx 37 (550 x 685 x x 27 mm) 37 (550 x 6 DExterior dimension (W x D x H) x H) TM (1/2 HP) Compressor sor system achieves an approximately 40% 400W (1/2 HP) V. I. P. PLUS Weight Rotary type, Output: Net enables reducing the thickApprox. (67kg) Inner Inner dimension 3" Box: 30pcs dimension 15. 9" x 19. 3" x 16. 9" (405550W/600W mm)16. 9" (405 x x15. 9"xx430 x 490 19. 3" Refrigerant 42pcs. (SCR-072power consumption and en- HFC Refrigerant model* HFC Conventional MDF-C8V insulation* MDF-C8V Storage Capacity insulation* Conventional reduction in x 6 racks) 2" box: ness of insulation to approximately one half 3. 0cu. ft. (84 Liter) Tube capacitytype Evaporator Tube on sheet *SANYO comparison (115V, 60Hz/230V, 50Hz) Outer conventional systems. Small Door/Inner Door Outer Lid:Effective capacity1 piece Effective on sheet type 1 piece, Inner Lid: ables low-noise operation. [. . . ] ­80 ed by: ted by: 430 (16. 9") 0 1 2 Time (hour) 3 4 5 6 7 430 (16. 9") ­100 ­120 Time (hour) SCR-072-I SCR-072-I Pull-down characteristics Pull-up characteristics during power failure CO2 backup system operation characteristics SCR-053-I SCR-053-I Dimensions [Unit mm Options Dimensions Options : 12 (inch)] 20[Unit : mm (inch)] 40 CVK-UB4 (I) CVK-UB4 (I) New cooling circuit enables filterCentral air temp. in cabinet 20 0 LCO2 Back-up LCO2 Back-up Temperature Recorder 729 (28. 7") Ambient temp. 30°C, No-load Back-up system 729 (28. 7") less structure Back-up system 0 system system ­20 15 mounting kit mounting kit ­20 550 (21. 6") 685 (27. 0") 58 (2. 3") 685 (27. 0") 550 (21. 6") 58 (2. 3") A new cooling circuit makes the inconve44 (1. 7") 39 (1. 5") 44 (1. 7") MDF-UBK39 (1. 5") MDF-UBK ­40 ­40 of ­70°C by injection of LCO2 (30kg) 5. 65 sq. ft 4. 05 sq. ft ­100 ­120 Time Performance Data (hour) 0 1 2 3 4 5 6 ­100 ­120 7 80 of ­70°C by injection of LCO2 (30kg) Am of ­ ­100 10 2 Inventory rack Inventory (hour) Time (hour)rack Time 3 1 4 2 5 3 6 4 7 5 8 6 7 ­100 80 1 0 2 5 Time (hour) Ambient temperature (°C) 3 10 4 15 5 6 20 7 25 8 30 A Tem 8 ­100 0 1 2 Time (hour) 3 4 5 6 7 8 0 5 Ambient temperature (°C) 10 MTR-C954 15 20 25 30 35 MTR 945 (37. 2") 945 (37. 2") 887 (34. 9") 887 (34. 9") Medical devices Quality management system:ISO13485/Environmental management Electric Co. , Ltd. SANYO system:ISO14001 729 (28. 7") 58 (2. 3") 550 (21. 6") 44 (1. 7") 685 (27. 0") SANYO Sales & Marketing Corporation SANYO Sales & Marketingsystem Corporation URL http://www. sanyo. co. jp/cmg/biomedical Product conforms to RoHS (European Restriction of HazardousURL http://www. sanyo. co. jp/cmg/biomedical (I) Substance directives) CVK-UB4 ©2006 SANYO Printed inin Japan 2006. 10. [. . . ]