User manual SANYO MPX-CD92

[. . . ] Before installing and using this unit, please read this manual · carefully. Be sure to keep it handy for later reference. This manual gives basic connections and operating instructions for 2 models (Color MPX-CD92, B/W MPX-MD92). This device complies with Part 15 of the FCC Rules. [. . . ] MODE2: The live pictures from the camera for which programmed recording is set are recorded together with the live pictures from the other cameras. If the VCR is not Equipped with a SW (switching) Output Connector The recording speed settings on this unit correspond to recording durations on a T-120 tape. With a timelapse VCR Set the recording speed to match the recording speed of the timelapse VCR. The available speeds are: 2 (2H) (Default setting), 12 (12H), 24 (24H), 48 (48H), 72 (72H), 96 (96H), 120, 168, 240, 360, 480, 720, 960 (960H) With a real time VCR Set the recording speed to match the recording speed of the real time VCR. the available speeds are: 6 (6H) (Default setting) , 18 (18H) , 30 (30H) , 48 (48H) , 72 (72H) , 96 (96H) , 120 , 168 , 240 , 360 , 480 , 720 , 960 (960H) NOTE: Real time VCRs speed is based on a T-160 cassette tape. When setting this unit to 6H, 18H or 30H, refer to the table 1 for the speed correspondence, and select the speed on the VCR accordingly. Programmed recording of multiple cameras is done by switching to each camera in order. In the (CAMERA SET) menu, set for each camera if programmed recording is to be conducted or not (see page 36). the recording mode set here is the same as the ACTIVE REC recording mode (see page 34). The programmed recording mode is the normal recording mode applied to the camera, while the active recording mode will modify the recording mode for the camera when an external alarm or a video sensor trigger is received. Any camera for which programmed recording is turned off, will not be recorded when an external alarm or a video sensor trigger is received. To record from a camera for which programmed recording is turned off, when an external alarm or a video sensor trigger is received, set the active recording mode to on. Used to playback a tape recorded through a black and white multiplexer, using a color multiplexer. ON: When using a black and white tape, the color killer function is active. OFF: The color killer function is not active. If the VCR is Equipped with a SW (switching) Output Connector (using the VCR switching signal) Make the connection from this unit to the VCR SW output connector. The video signal output by this unit will be automatically switched to the recording speed according to the switching signal output by the VCR (switching pulse setting on the VCR). the (VCR SET) menu "REC SPEED" and "ALARM REC SPEED" items do not need to be set. If a switching signal is not output at the switching terminal Some VCR models may not output a switching signal in 2H or 6H mode. If multiple units are going to be controlled through a system controller (sold separately) via the RS485 connection, each unit must have a address for remote control purposes. The address set for the unit can be checked by accessing the (VCR SET) menu. NOTE: When the recording speed is set to F2 or F6, the alarm recording speed is fixed to 2H or 6H. [. . . ] mENU (74) To display the menu on monitor 1. + (65), ­ (66) To select settings (ON/OFF, numbers, letters, symbols) in the menus. 1-7: To setup the multiplexer address (only when using the RS-485 connector). When this command is sent from the computer, this unit will send a 5-byte response (see Table 1). [. . . ]