User manual SANYO PLC-WXU10N

[. . . ] English EN-1 To the Owner Before operating this projector, read this manual thoroughly and operate the projector properly. This projector provides many convenient features and functions. Operating the projector properly enables you to manage those features and maintains it in better condition for a considerable time. Improper operation may result in not only shortening the product-life, but also malfunctions, fire hazard, or other accidents. [. . . ] Complete the AC power cord and peripheral signal cable(s) connections. Press ON / STAND-BY button to turn on the projector. Turn on your source (computer, notebook, DVD, etc. ). The projector automatically detects your source. When searching message appears on the screen, ensure that the appropriate signal cable(s) are securely connected. The signal message will appear on the screen when the source is detected. If you are connecting multiple sources to the projector simultaneously, press INPUT button. Remove the lens cap first before powering on. Never look into the lens when the lamp is on. It is especially important that children are not allowed to look into the lens. To avoid image sticking, it is not recommended that you project the same still image for more than 15 minutes. Faster on-off-cycles will damage the lamp and reduce lamp life. Wait at least for 7 minutes to turn off the projector after powering on. Powering Off the Projector: 1. Press ON / STAND-BY button to turn off the projector lamp. Press Power again" appear on the screen. Press ON / STAND-BY button again to confirm. The cooling fans continue to operate for cooling cycle and the Lamp LED goes out. When the Power LED begins flashing, the projector has entered standby mode. If you wish to turn the projector back on, you must wait until the projector has completed the cooling cycle and has entered standby mode. Once in standby mode, simply press ON / STAND-BY button to restart the projector. Disconnect the power cord from the electrical outlet and the projector. Please wait until the fan motor and the Lamp LED turn off before removing the AC power cord from the projector. Faster on-off-cycles will damage the lamp and reduce lamp life. Wait at least for 7 minutes to turn off the projector after powering on. EN-18 Adjusting the Projected Image Adjusting the Projector Height Elevator button Elevator foot The projector is equipped with two elevator feet to adjust the image height up to 9. 0 degrees. [. . . ] 14) The input signal is not supported Press remote control's "AUTO PC" Partial, scrolling button. 12, 14, 27) o r i n c o r r e c t l y by the projector. Image is unstable or The signal timing of the display Use "Fine Sync" to correct it. Refer does not synchronize with the to Picture section. [. . . ]