User manual SANYO PLC-XW250

[. . . ] Owner's Manual Network Set-up and Operation Wired Setting Projector Set-up and Operation This is the manual for the Network function. Read this manual thoroughly to operate the Network function. First, read the owner's manual of the projector to understand the basic operation of the projector and the safety instructions. The safety instructions in the owner's manuals should be followed strictly. Compliance Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] By clicking ON or Standby button on the page, the power of the projector can be controlled. Confirmation window as shown in the below appears when the Standby button is pressed. Popup confirmation window Item Description PJ status Power . . . . . . . . . . . . . . . . . . . . . . . . . (ON, OFF, On starting up, On cooling down) Status . . . . . . . . . . . . . . . . . . . . . . . . . . Displays the status of the projector's power. (Refer to next page. ) Powercontrol . . . . . . . . Controls the projector power by clicking the "ON" or "Standby" button. The projector cannot be turned on while the projector is on cooling down. The web browser checks and updates the projector's condition every 30 seconds automatically. Power control and status check About projector condition Status Description Normal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Power management is operating Lampfailure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Lamp failure is occurring AbnormalTemperature . . . . . . . . . . . . . . . . . . . . . . . . . The temperature of the projector became too high StandbyafterAbnormalTemp. Powerfailure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Power failure has occurred inside the projector. Unplug the AC cord and ask servicing to a qualified service personnel. When a security (PIN code lock) has been set on the projector, you also cannot control it through the network. To control the projector through the network, unlock the security on the projector using with the projector's menu control. Caution about turning on/off the projector via the networks When turning on/off the projector via the networks, preset the projector as follows: 1. Select "Setting" from the Projector menu. Select "Standby mode" from the Setting menu and set it as "Network". If you set this function as Network, the network part of the projector is constantly provided with power even if the projector is turned off. If you set this as Eco, then the network part will be turned off when you turn off the projector. Consequently, you cannot turn on/off the projector via the networks. ENGLISH Chapter 4 Controlling the Projector Control Click Control on the main menu. The setting method differs depending on the contents of the page. Click on the page number to change pages and select desired setting items. Please see the owner's manual of the projector to have the further information of each control item. Input This function is to select the input mode and source mode of the projector. [. . . ] A The display speed of the page depends on the network environment in which both the projector and computer are placed. It may take much time to complete the page display if network traffic is heavy. Please consult your network administrator. Q How many numbers of the E-mail address can I register in the E-mail setting page. A You can register up to 10 addresses. Q Why am I not receiving E-mail alert messages?A Make sure that the registered E-mail address and SMTP server address are correct. [. . . ]