User manual SANYO PLCEF10N

[. . . ] If your projector seems to operate improperly, read this manual again, check operations and cable connections and try the solutions in the "Trouble-shooting" section of the end of this booklet. If the problem still persists, contact the sales dealer where you purchased the projector or the service center. SAFETY PRECAUTIONS WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. q This projector produces intense light from the projection lens. Do not stare directly into the lens as possible. [. . . ] TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU TURN THE PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF. When the Power Management function is ON, the Projector detects the signal interruption and turns the Projection Lamp off automatically. Refer to "Power Management" on page 48. When the TEMPERATURE WARNING indicator flashes red, the projector is automatically turned off. Wait at least 5 minutes before turning the projector on again. When the TEMPERATURE WARNING indicator continues to flash, follow procedures below: 1. Turn the MAIN ON / OFF SWITCH to OFF and disconnect the AC power cord from the AC outlet. Check the air filters for dust accumulation. (See "AIR FILTER CARE AND CLEANING" section on page 51. ) 4. If the TEMPERATURE WARNING indicator should still continue to flash, contact the sales dealer where you purchased this projector or service center. NOTE: The Cooling Fan may work for cooling while the projector is turned off. When the Cooling Fan is working, TEMPERATURE WARNING INDICATOR flashes red. 32 BASIC OPERATION ADJUSTING THE IMAGE ZOOM ADJUSTMENT Use Top control and Wireless/Wired remote control unit. Press the ZOOM (v) or (w) button to obtain your desired picture size. For a larger picture, press (v) and for a smaller picture, press (w). Use Wireless remote control unit. Press the ZOOM button and press POINT UP/DOWN button(s) to obtain your desired picture size. The item(s) indicated "ON" in the AUTO IMAGE ADJUSTMENT are adjusted automatically. If all the items in AUTO IMAGE ADJUSTMENT are "OFF", AUTO IMAGE SETTING display appears. If you wish to operate the AUTO IMAGE ADJUSTMENT, perform the steps 1 - 3 of "AUTO IMAGE ADJUSTMENT" section on page 41. CURSOR FUNCTION Press the CURSOR button on the wireless remote control unit. Press POINT UP/DOWN/LEFT/RIGHT (POINTING PAD) button(s) to control CURSOR. The CURSOR is moved according to the direction you are pressing. Press CURSOR button again, and CURSOR disappears. 34 BASIC OPERATION SOUND ADJUSTMENT DIRECT OPERATION Sound Volume Adjustment Press the VOLUME (+/­) button(s) on the Top Control or on the Remote Control Unit to adjust the volume. The Volume dialog box appears on the screen for a few seconds. (+) button to increase the volume, and (­) button decreasing. Indicates the roughly level of the volume. Sound Mute Setting Press the MUTE button on the Remote Control Unit to cut off the sound. To restore the sound to its previous level, press the MUTE button again or press Volume (+/­) button(s). Press the MUTE button to set the Mute function On or Off. The display disappears after 4 seconds. MENU OPERATION 1 2 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to select SOUND and press the SELECT (REAR CLICK) button. [. . . ] (See "SETTING" section on pages 48 ~ 49). q q q q Check audio cable connection from audio input source. Press the MUTE button. Picture is L/R Reversed. Some displays are not seen during the operation. [. . . ]