User manual SANYO PLCSP10N

[. . . ] Before you do, we suggest that your spend a little time reading this manual to familiarize yourself with the operating procedures so that you will receive maximum satisfaction from the many features included in your new projector. This owner's manual will acquaint you with your projector's features. Through the years, we have found that many service requests were not caused by problems with our projectors. They were caused by problems that could have been prevented, if the owner had followed the instructions in the manual. [. . . ] The "Normal" display will be displayed on the screen for a few seconds. Normal 27 COMPUTER MODE AUTO IMAGE FUNCTION The Auto Image function is provided to automatically adjust Fine sync. , Total dots, and Picture Position for most computers. 1 2 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to select AUTO IMAGE and press the SELECT button. Another dialog box AUTO IMAGE Menu will appear. Move the arrow to an item that you want to adjust by pressing the POINT UP/DOWN button. Change the setting On or Off by pressing the SELECT button. Fine sync. Adjust the picture as necessary to eliminate flicker from the display. (Refer to page 27. ) Total dots The number of the total dots in one horizontal period. (Refer to page 27. ) Position Adjustment of the position of the image. (Refer to page 28. ) Starts the adjustment on the item set to "On". Close the PICTURE IMAGE ADJUSTMENT Menu. Move the arrow to the item and then press the SELECT button. 3 Move the arrow to "Go!" and press the SELECT button to start the Auto Image function. The maximum size of the projected image in expand mode is 4 times as large as the screen size (800 x 600). Compress function To compress the image size, press the D. ZOOM w button or the RIGHT CLICK button. The size of image is reduced by degrees. The minimum size of the projected image in compress mode is 640 x 480 in VGA or 800 x 600 in SVGA / XGA. Panning function To pan the image, press the POINT UP/DOWN/LEFT/RIGHT buttons. Panning function can work only when the image is larger than the screen size. To cancel Digital Zoom mode, press the any buttons except D. ZOOM v/w, SELECT, RIGHT CLICK, POINT, PAGE v/w or LASER button. To adjust the image to the screen size (800 x 600), press NORMAL button. q This projector cannot display in the resolution higher than 1024 X 768. If your computer's screen resolution is higher than 1024 X 768, reset the resolution to the lower before connecting the projector. q The image data in other than SVGA (800 x 600) is modified to fit the screen size in the initial mode. q The normal "Panning Operation" may not function properly if the computer system prepared with the "PC Adjust" is used. 29 VIDEO MODE SELECTING VIDEO MODE DIRECT OPERATION Select VIDEO mode by pressing the MODE button on the Top Control or the VIDEO button on the Remote Control Unit. MODE button COMPUTER MCI MENU OPERATION Press the MENU button and the ON-SCREEN MENU will appear. [. . . ] q Check Media Card Imager (supplied) is installed in your computer properly. q Check the setting in Media Card Imager (like Serial Port Setting) is set properly. Wireless Mouse function does not work. The image data in memory card isn't displayed. The image data can't be written in, read from the memory card. WARNING : High voltages are used to operate this projector. Do not attempt to open the cabinet. Sanyo Service is easily obtained. [. . . ]