User manual SANYO PLCXP10NA

[. . . ] If your projector seems to operate improperly, read this manual again, check operations and cable connections and try the solutions in the "TROUBLESHOOTING" section at the end of this booklet. If the problem still persists, contact the sales dealer where you purchased the projector or the service center. SAFETY PRECAUTIONS WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. G This projector produces intense light from the projection lens. Do not stare directly into the lens as it could possibly damage your eyes. [. . . ] (Refer to P24 and 25. ) There is no signal input from the connected computer. Make sure the connection of the computer and the projector is set correctly. (Refer to TROUBLESHOOTING on page 40. ) PC SYSTEM MENU SYSTEM Menu icon Displays system being selected. ­­­ SELECT COMPUTER SYSTEM MANUALLY PC system can also be selected manually. PC SYSTEM MENU 1 2 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to move the red frame pointer to the PC SYSTEM Menu icon. Press the POINT DOWN button to move the red arrow pointer to the system that you want to set, and then press the SELECT button. SYSTEM Menu icon Displays system being selected. The systems on this dialog box can be selected. Custom Mode (1~5) set in the PC ADJUST Menu. (P24, 25) 22 COMPUTER INPUT PC ADJUSTMENT AUTO PC ADJUSTMENT Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots and Picture Position to conform to your computer. Auto PC Adjustment function can be operated as follows. Auto PC Adj. 1 2 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT button to move the red frame pointer to the PC ADJUST Menu icon. Press the POINT LEFT/RIGHT button(s) to adjust the position. Vertical Adjusts vertical picture position. Press the POINT LEFT/RIGHT button(s) to adjust the position. Current mode Press the SELECT button to show the information of the computer selected. When the image has a dark bar(s), try this adjustment. Current mode Press the POINT LEFT/RIGHT button to adjust the value. Press the SELECT button at this icon to adjust "Clamp, " "Display area (H/V)" or set "Full screen. " Selected Mode Shows status (Stored / Free) of the selected Mode. Press the SELECT button at the Current mode icon to show the information of the computer connected. 24 COMPUTER INPUT Display area Selects the area displayed by this projector. Select the resolution at the Display area dialog box. Display area H Adjustment of the horizontal area displayed by this projector. Press the POINT LEFT/RIGHT button(s) to decrease/increase value and then press the SELECT button. Display area V Adjustment of the vertical area displayed with this projector. [. . . ] (The AC Power Cord is unplugged. ) The projector is READY to be turned on with the POWER ON-OFF button. The projector is operating normally. The temperature inside the projector is abnormally high. When the projector is cooled down enough and the temperature returns to normal, the READY indicator lights green and the WARNING TEMP. Then the projector can be turned on. The projector is being cooled down. It cannot be turned on until the READY indicator lights green. The projector is in the Power management mode. · · · on · · · flashing · · · dim · · · off When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. [. . . ]