User manual SANYO PLCXU10N

[. . . ] Multimedia Projector MODEL PLC-XU10N Owner's Manual INFORMATION TO THE USER NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. TO THE OWNER As the owner of a new Multimedia Projector, you are probably eager to try out your new projector. [. . . ] Press the POINT LEFT/RIGHT buttons to select IMAGE and press the SELECT button. Another dialog box PICTURE IMAGE ADJUSTMENT Menu will appear. Press the POINT DOWN button and a red-arrow icon will appear. Move the arrow to v or w of the item that you want to change by pressing the POINT UP/DOWN buttons. To increase the value, point the arrow to v and then press the SELECT button. To decrease the value point the arrow to w and then press the SELECT button. Fine sync Adjust the picture as necessary to eliminate flicker from the display. (From 0 to 127. ) This item can be adjusted by pressing the FINE SYNC. button on the Top Control or the Remote Control Units. Total dots The number of the total dots in one horizontal period. Adjust the number to match your PC image. White Balance (Red / Green / Blue) Point to w to adjust the color of image lighter, and select v to adjust the image deeper. (From 0 to 63. ) Contrast Point to w to adjust the image lighter, and select v to adjust the image deeper. (From 0 to 63. ) Brightness Point to w to adjust the image darker, and select v to adjust the image brighter. (From 0 to 63. ) Each of the keys operates as follow. It indicates the roughly level of the item. Move the arrow to v or w and press the SELECT button. It closes the PICTURE IMAGE ADJUSTMENT Menu. Reset Stored Quit It recalls the data previously adjusted. It stores the adjusted data in the memory. It closes the PICTURE IMAGE ADJUSTMENT Menu. 28 COMPUTER MODE Auto Image Function The Auto Image function is provided to automatically adjust Fine sync. , Total dots, and Picture Position for most computers. 1 2 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to select AUTO IMAGE and press the SELECT button. Another dialog box AUTO IMAGE Menu will appear. Move the arrow to an item that you want to adjust by pressing the POINT UP/DOWN button. Change the setting On or Off by pressing the SELECT button. Adjust the picture as necessary to eliminate flicker from the display. (Refer to page 28. ) The number of the total dots in one horizontal period. [. . . ] q Check the memory card is inserted properly into PC CARD SLOT. q Check Media Card Imager (supplied) is installed in your computer properly. q Check the setting in Media Card Imager (like Serial Port Setting) is set properly. WARNING : High voltages are used to operate this projector. Do not attempt to open the cabinet. Sanyo Service is easily obtained. [. . . ]