User manual SANYO POA-FIL160

[. . . ] Loosen the 2 screws that secure the AMC unit and pull it out. Insert the Smoke Resistant Unit into the projector completely and fix it with the 2 screws. [. . . ] - If the filter or the unit is not replaced, do not reset the Filter counter. Disable when using the Smoke Resistant Unit. Replacing the Smoke Resistant Filter 1 2 3 4 5 Press the ON/STAND-BY button on the side control or the STAND-BY button on the remote control, flip the Main On/Off Switch off, and then unplug the AC power cord from the AC outlet. Loosen the 2 screws that secure the Smoke Resistant Unit and pull it out. Loosen the 3 screws that secure the holders. Press and hold down the holders: A and B, and remove them. After inserting your fingers through the slits and lifting the Smoke Resistant Filter to remove them easily. Insert the new Smoke Resistant Filter tightly by gently pressing down the filter with your fingertips. - Place the filter with the sponge side up. Smoke Resistant Unit 2 Screws 3 Holder B Holder A Screws 3 6 7 8 9 Put the holders on the filter. Slide backward the holders until the arrow marks on the holders are aligned with those on the Smoke Resistant Unit. Insert the Smoke Resistant Unit into the projector completely and fix it with the 2 screws. Plug the power cord, power on the projector and reset the filter counter. 4 ORDER REPLACEMENT FILTER When ordering a Smoke Resistant Filter, provide the following model No. to the sales dealer: POA-FIL-160 English CAUTION · When the "Filter counter remaining" reaches 10%, it is recommended to replace with a new filter. · This filter is designed for use in smoky environments. [. . . ] Do not operate at the ambient temperature exceeding noted above. At an altitude above 500 m, the operating temperature ranges from +41°F to +86°F (from +5°C to +30°C). [. . . ]